Xerox Color C60/C70 Series Manuel d'installation - Page 19

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Xerox Color C60/C70 Series. Xerox Color C60/C70 Series 35 pages. Customer expectation & installation guide

Imprimer la page

Xerox Color C60/C70 Series Manuel d'installation

Detailed Specifications

• The GBC

• Hole punch position from edge of paper is not adjustable.

• Opening the door of the GBC

• Gloss coated media may not run as reliably as uncoated paper. Typically, coated papers and high area

• Punching 8 ½ x 11 duplexed coated stock using the GBC 3-hole punch (008R13072) is not recommended

• Pre drilled stock LEF is not supported by The GBC

• Due to the nature of punching holes, each punched sheet is slightly deformed, and when stacked, the edge

• A4 and LTR punch units are not the same; therefore, A4 and LTR die sets are not interchangeable.

• The LTR punch unit will be shipped with the 19-hole punch die.

• The A4 unit will ship with the 21-hole punch die.

• Additional punch dies are available for order (see below)

• Up to 3 additional die sets can be stored inside the GBC

• Punch Dies

• In the Western Hemisphere (8 ½ x 11 inch) punch dies are ordered using the Supplies ordering process; in

• A4 and Letter version die sets are not interchangeable.

• Please note: Punch die life will be increased if the wick material is lightly oiled every 50,000 punch cycles

Customer Expectation and Installation Guide

Pre-printed Tabs cannot be punched

AdvancedPunch™ is supported by all color servers.

AdvancedPunch™ supports media from 75 to 216 gm

ProClick die supports media from 75 to 203 gm

AdvancedPunch™ supports tab stock no wider than 9"; oversized tabs may be damaged..

Stacking may be misaligned on jobs containing tab stock; these jobs will require additional

jogging before final finishing.

AdvancedPunch™ is able to bypass all coated and uncoated media sizes printed on the Xerox

560/570 Digital Color Press.

and shut down.

coverage exhibit increased variability in paper handling due to lower coefficients of friction. This may result in

varied punch registration and increased jam rates.

due to greatly increased paper jams.

using SEF

with the holes will have an increased height as compared to the non-punched edge.

Reduced stack quality may be experienced due to variability in the punch hole formation.

The stack height can be effected by many factors, such as: paper type, quality, weight and

curl, as well as die type, age and condition. Paper curl is best when it has a slight downward

curl on the edges. This can be adjusted by the operator while running prints.

The GBC

AdvancedPunch™ is capable of punching a variety of hole-punch patterns by simply changing the

punch die. Punch dies can be changed in seconds without tools. The punch dies currently available are listed

below. Each die set has a 90 day warranty from date of purchase.

Europe (A4) punches are ordered through sales representatives; please check for availability.

(approximately every month) with quality machine oil such as 3-in-1 Oil. Small deposits of oil will be observed

around the perimeter of the punched holes until the excess oil is absorbed (usually within 20 sheets).

AdvancedPunch™ while the machine is running will cause the machine to jam

AdvancedPunch™, however predrilled stock may be run

AdvancedPunch™.

Xerox Color

, coated and uncoated.

C60/C70