Direct power DPB053STM Manuel de sécurité et d'utilisation - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel de sécurité et d'utilisation pour {nom_de_la_catégorie} Direct power DPB053STM. Direct power DPB053STM 17 pages. 2000w wallpaper stripper

Imprimer la page

2. Attaching the power lead (Fig 3)

Plug the adaptor end of the power lead into

socket (10). It is advisable to use a residual current

device(RCD-D) in conjunction with this unit.

Note: This unit will automatically begin the

boiling process when power is swithched on at

the mains socket.

3. Stripping

Warning: Just before steam is produced, a

small amount of bubbling hot water will be

emitted from the wallpaper stripper .

Typically it takes 10 minutes before full steam

is achieved . During this time the vapour hood

should be placed in a position where the water

and steam that is emitted does not cause any

damage.

Caution: Check the state of the plaster

before steaming. If the plaster is loose or

sounds hollow it may be damaged further by

steaming.

To achieve the fastest paper removal:

1. Gently score the areas to be stripped. (With

heavily embossed, vinyl coated or painted paper

this is essential).

2. Either use a proprietary perforator tool or

alternatively score the paper with the edge of a

wallpaper scraper in a criss-cross pattern with a

spacing of approximately 150mm (6").

3. Hold the steam plate ﬂat against the wall for

approximately 10 seconds. (Fig 4)

4. Move the steam plate to the area immediately

beside the one just steamed and use a wallpaper

scraper to remove the paper from the steamed

area.

Note: Working in this way allows continuous

wallpaper removal. For some types of paper, or if

there is more than one layer of paper, the time may

need to be extended. Always wear suitable heat

resistant gloves and a long sleeved top. Beware

of hot water accumulating in the steam plate as

this could cause burns if spilt. Do not allow steam

near or into electrical outlets or ﬁttings.

5. Operate until the water level reaches the MIN

mark on the water tank, then unplug the water

tank and allow it to cool for at least 5 minutes

before removing the ﬁller cap.

Never use the steamer for more than 2 hours at

one time as this will cause the steamer to boil

2000W WALLPAPER STRIPPER

TWS200-M-070924.indd 9

Fig 3

Fig 4

DPB053STM

2007-9-25 15:45:02