Xerox DocuColor 240 Note de mise à jour - Page 4

Parcourez en ligne ou téléchargez le pdf Note de mise à jour pour {nom_de_la_catégorie} Xerox DocuColor 240. Xerox DocuColor 240 34 pages. Printer-copier
Également pour Xerox DocuColor 240 : Manuel de démarrage rapide (47 pages), Manuel d'installation (2 pages), Manuel de démarrage rapide (2 pages), Manuel de remplacement du matériel (2 pages), Manuel de paramétrage (6 pages), Création de livrets pour la copie (2 pages), Liste des paramètres système (2 pages), Manuel de démarrage rapide (2 pages), Manuel de démarrage rapide (2 pages), Manuel de l'évaluateur (20 pages), Manuel de l'évaluateur (18 pages)

LDAP Server Setup

If you enable an LDAP server (in More Setup), you must also meet the following

requirements:

• Make sure the LDAP server IP address and host name are registered on the DNS server

and that DNS Setup is enabled on the Fiery. To enable DNS Setup, select Enable DNS

Setup in the Protocol2 tab under Network Setup.

• You must enable the Fiery e-mail service (on the Service3 tab under Network Setup) to

allow LDAP to access corporate e-mail addresses from Remote Scan.

• In a Windows Server 2003 Active Directory DNS environment, add the Fiery to the

Windows Active Directory Domain. Otherwise, the LDAP feature might not be able

to resolve the LDAP Server name. The Windows domain setting is on Service 2 tab of

Network Setup.

• Make sure the time difference between the LDAP server and the System Time of the Fiery

is 5 minutes or less. You can set the time on the Fiery using WebSetup.

WebSetup on Mac OS X

To use WebTools on Mac OS X, set the display resolution to 1280

Otherwise, some options in WebSetup may be hidden.

Job Log Setup

You must enable both Auto Print Job Log After 55 Jobs and Auto Clear Job Log After 55 Jobs

for those features to function properly. Disabling either one of them results in both features

not functioning.

Error History Report

The Error History Report shows the error "027-741 Job Template Server Connect Fail" each

time the Fiery is rebooted. This message is triggered as part of the normal start-up sequence

and does not indicate an error condition.

Member Printing

If Member Printing is enabled, you cannot download ﬁles from Downloader,

WebDownloader, or Command WorkStation. If Member Printing is enabled, do one of

the following:

• Print directly from the application in which the ﬁle was created.

• Download the ﬁle to the Hold queue, change the owner information for the job with

Command WorkStation, and send the job to print.

Printing Groups

WebSetup allows you only to enable or disable the use of Printing Groups. To deﬁne the

actual groups, use Command WorkStation.

Page 4

1040 or higher.

Part Number: 45045321