Xerox 3825 Manuel de l'utilisateur - Page 16

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Xerox 3825. Xerox 3825 28 pages. Xerox 3812: user guide

Installation and setup

Printing a trace job within DocuSP IPS Manager

2-8

During the installation process, three sample DocuSP IPDS trace jobs

are provided. These jobs can be used to either verify printer

operability after the DocuSP IPDS software is installed or for

diagnostic purposes:

•

afptrace.let — prints a sample IPDS job formatted for US Letter paper

•

afptrace.a4— prints a sample IPDS job formatted for A4 paper

•

scfont.trc— prints a sample IPDS job using resident outline fonts

formatted for either US Letter or A4 paper.

In order for the trace scfont.trc to print correctly, the IBM AFP fonts

must be loaded on the printer and Enhanced Font Support must be

enabled.

NOTE: These jobs test only DocuSP IPDS processing on the printer.

The trace files are set up to use the installation default parameters. If

you plan to run the A4 trace instead of the US Letter trace, change the

Media Definition for the DocuSP IPDS Tray 1 from US Letter to A4. In

DocuSP IPDS, you must map a medium to each DocuSP IPDS tray

specified in the IPDS data stream.

For the installation verification jobs, use US Letter or A4 media. Refer to

the DocuSP IPDS on-line help for the specific procedures.

To verify host-to-printer communications, perform these steps to print

a test job from the host:

Step 1. Ensure DocuSP IPDS is running and is reporting a status of

DocuSP IPDS Idle.

Step 2. Start the logical printer from the host and verify that it is

active.

Step 3. Send an IPDS print data stream from the host to the DocuSP

Xerox DocuSP IPDS User Guide