Xerox 6180DN - Phaser Color Laser Printer Manuel de démarrage - Page 29

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage pour {nom_de_la_catégorie} Xerox 6180DN - Phaser Color Laser Printer. Xerox 6180DN - Phaser Color Laser Printer 34 pages. 26-ppm monochrome/ 20-ppm color
Également pour Xerox 6180DN - Phaser Color Laser Printer : Manuel d'installation (34 pages), Fiche technique (2 pages), Manuel de l'utilisateur (32 pages), Manuel de l'utilisateur (28 pages), Manuel d'installation (2 pages), Manuel de sécurité (38 pages), Note de mise à jour (2 pages), Manuel d'installation (2 pages), Manuel de démarrage (37 pages), Manuel (34 pages), Manuel (34 pages), Manuel de l'utilisateur (32 pages), Manuel d'installation et d'utilisation (8 pages), Spécifications (4 pages), Manuel (28 pages)

Nuvera Stacker/Finisher Script

For the Nuvera family of printers, you must use the following script

to set up Stackers and/or Finishers:

1. Open a terminal window.

2. Login as root.

3. Type cd /opt/XRXnps/bin/DFA_IsStacker.

4. Press <Enter>.

5. Type ./set –f 0 OR ./set –f 1. Use the value 0 if the

attached DFA device is a finisher, or use the value of 1 if

the attached DFA device is a stacker. Note that there are

spaces before and after the –f switch.

6. Restart DocuSP.

NOTE: This setting is lost on an upgrade or a scrape install

and must be recreated using this procedure.

Prior to DocuSP 4.0, the controller applied the LPR gateway

filename to submitted documents as opposed to the internally set

document name. Starting with DocuSP 4.0, the controller applies

the internal document name to the job.

To set the DocuSP to the pre-4.0 behavior, run the following script:

1. Open a terminal window.

2. Login as root.

3. Type enablePre40LPRBehavior

4. Press <Enter>.

5. To disable the pre-4.0 LPR behavior, type

disablePre40LPRBehavior

6. Restart DocuSP.

NOTE: A document name set in the job ticket has a higher

precedence than the LPR gateway and internal document

attributes.