Xerox 6180DN - Phaser Color Laser Printer Manuel de démarrage - Page 23

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage pour {nom_de_la_catégorie} Xerox 6180DN - Phaser Color Laser Printer. Xerox 6180DN - Phaser Color Laser Printer 34 pages. 26-ppm monochrome/ 20-ppm color
Également pour Xerox 6180DN - Phaser Color Laser Printer : Manuel d'installation (34 pages), Fiche technique (2 pages), Manuel de l'utilisateur (32 pages), Manuel de l'utilisateur (28 pages), Manuel d'installation (2 pages), Manuel de sécurité (38 pages), Note de mise à jour (2 pages), Manuel d'installation (2 pages), Manuel de démarrage (37 pages), Manuel (34 pages), Manuel (34 pages), Manuel de l'utilisateur (32 pages), Manuel d'installation et d'utilisation (8 pages), Spécifications (4 pages), Manuel (28 pages)

Imprimer la page
Xerox 6180DN - Phaser Color Laser Printer Manuel de démarrage
19
Caveat
Copy-Sensitive CME jobs print with extra
pages.
Avoidance: Program a Copy-Sensitive CME in
the START JDL, even if it is a CME
CONSTANT to print a space. The output
prints correctly.
Long jobs that are simplex with a solid
highlight color image in the same location on
each page may cause staining on the fuser
that appears on subsequent jobs. Contact the
Xerox customer support center for assistance.
Jobs programmed with front covers do not
print.
Avoid programming front covers at this time.
Programming a negative shift with JIS B4
stock causes a misalignment between the
black and highlight color images.
Use of DHCP is not recommended. Assign a
static IP address for the system.
DocuSP Remote Workflow does not run in the
Solaris operating system. Use Remote
Workflow on a Windows platform only.
Mismatch processing for highlight color
printing is not supported for IPDS. When
performing highlight color printing, the IPDS
decomposer always prints in the loaded color.
In addition, transparent highlight color mode is
not supported.
Restarting DocuSP causes Remote Services
to restart. Do not restart DocuSP while
capturing or transferring data.
A C17-350 fault occurs when the system
attempts to backup the billing meter
information when the printer is switched off.
Switch on the printer and restart the DocuSP
software to clear the error.
The DocuSP 4.x UI functions much slower on
an Sun Ultra 2.
In Printers, Stackers, if a selection is made for
All Stackers, the selection is not modified for
all. Select each stacker individually and make
the necessary change.
The Reposition Output display only shows the
end of the job and does not show the end of
the set.
Applicable printer product
All monochrome printers
DocuTech 180/155/128 HLC
DocuTech 180/155/128 HLC
DocuTech 180/155/128 HLC
DocuTech 180/155/128 HLC
DocuTech 180/155/128 HLC
DocuTech 180/155/128 HLC
DocuTech 180/155/128 HLC
DocuTech 61xx
DocuTech 61xx
DocuPrint 1xx EPS
DocuPrint 1xx EPS