Direct Supply ATLAS Manuel du propriétaire - Page 14
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Direct Supply ATLAS. Direct Supply ATLAS 17 pages. Sit-to-stand lift
Imprimer la page
Maintenance
Detecting Wear & Damage
Inspect slings, cradle/hanger bar and any pivot for slings frequently for signs of deterioration prior to
each use, such as cracking or fraying. Replace worn parts immediately, and ensure the lift is not used
until repairs are made.
Cleaning the Sling & Lift
The sling should be cleaned regularly in water (do not exceed 180°F (82°C)) and a biocidal
(antibiological) solution. DO NOT use bleach when laundering the slings. Please refer to the sling
manual and/or product label for correct washing instructions. Clean the resident lift with a damp, soft
cloth and a small amount of mild detergent. Clean the lift with nonabrasive cleaners.
Replacing the Boom Actuator
CAUTION: DO NOT overtighten the nut and bolt. This
damages the mounting bracket.
1. Remove snap ring, washer and lower actuator pin that
secure electric actuator to the mast mounting bracket.
2. Rest the boom on your shoulder and remove the nut,
bolt, plastic bushing and pinch guard from the boom
mounting bracket.
3. Remove the boom actuator assembly.
4. Reverse steps for installation.
Checking & Tightening Mast Pivot Bolt
a) Check that the bolt is through the bracket and the locknut
is tight and secure.
b) If needed, do one or more of the following:
• Tighten locknut and back off the locknut
• Replace the locknut.
26
(cont.)
Remove Upper
Bolt and Lower
Actuator Pin
Mast Pivot Bolt
⁄
of a turn.
1
8
Replacing Boom/Lift Arm
WARNING: After the fi rst year of use, the hooks of the boom/lift arm and mounting brackets of
the boom should be inspected every six months to determine the extent of wear. If these parts
become worn, replacement must be made prior to use.
The boom/lift arm is attached to the boom with bolt, nut and washers.
CAUTION: Washers should be placed against both sides of the boom mounting bracket to
prevent damage.
The boom/lift arm has one hook on both ends to attach the sling that supports the resident during lifts.
Remove existing hardware and replace the boom/lift arm.
CAUTION: DO NOT overtighten hardware. This damages the mounting bracket.
Adjusting Knee Pad Height & Depth
WARNING: NEVER adjust the knee pad while the resident is in standing position.
WARNING: NEVER try to adjust the knee pad while the lift is moving.
WARNING: ALWAYS make sure the threaded hand knobs are engaged in corresponding height-
adjustment holes before use.
NOTE: The knee pad should be positioned so the knee portion of the leg is in contact with the pad.
a) Pick a height setting that will be comfortable to the resident and provide the necessary support.
b) Loosen the three adjustment hand knobs by turning counterclockwise.
c) Position the knee pad to the desired height and depth, then tighten hand knobs by turning clockwise.
d) Check to ensure knee pad is in a comfortable position and hand knobs are tightened securely.
27
1-800-634-7328
DirectSupply.com