Calf-Tel MultiMax Instructions de montage - Page 2
Parcourez en ligne ou téléchargez le pdf Instructions de montage pour {nom_de_la_catégorie} Calf-Tel MultiMax. Calf-Tel MultiMax 4 pages.
Également pour Calf-Tel MultiMax : Manuel d'instructions de montage (7 pages)
Imprimer la page2.
Assemble the timber base
The base is built upside down and then flipped over to give a level top surface for
attaching the hutch. The longer, narrower pieces of timber at the front and back
provide a gap to insert loader tines to move the completed hutch easily.
a) To assemble the base you will need:
The bag of timber base fixings
Two pieces of side timber (2.14m x 150mm x 100mm)
Two pieces of front / back timber (2.5m x 100mm x 100mm)
b) Lay the timber components out on a flat area as shown below
Hutch Back
Timbers viewed from
above.
Hutch Front
c) Mark out and pre-drill one 8mm hole per corner as indicated by
d) Slide one washer onto each bolt & insert one bolt per corner into pre-drilled
holes.
e) Position L brackets against front & sides as indicated in the diagram.
f) Attach L brackets to timber with screws provided.
g) Lift and flip the base over so the upper surface is flush ready for the hutch to be
lowered on.
This picture shows the finished hutch mounted
on the timber.
2.5 m
L brackets
Drill holes and insert bolt
in each corner
L bracket