Yamaha 9000 Pro Manuel d'entretien - Page 20

Parcourez en ligne ou téléchargez le pdf Manuel d'entretien pour {nom_de_la_catégorie} Yamaha 9000 Pro. Yamaha 9000 Pro 20 pages. Professional workstation
Également pour Yamaha 9000 Pro : Manuel du propriétaire (35 pages)

Imprimer la page

1. Specifications

9000 Pro

[B] Optional Hard Disk Installation

The hard disk used must be a 2.5-inch IDE-compatible; however, not all such drives may be installable.

CAUTION

• When inserting hard disk unit and connecting cables, make sure that you check that they are inserted and

connected properly. Improperly inserted hard disk unit and cables may cause faulty contacts and an electri-

cal short circuit which may cause damage or result in a malfunction.

• After mounting the hard disk unit, be sure to tighten the screws as directed so it is completely stable and

does not move in any way.

• Hard disk drives of a maximum 8 GB capacity can be formatted; however, the maximum partition size is 2 GB. For

example, an 8 GB hard disk drive would have to be formatted into four separate 2 GB partitions.

• Hard disk drives of a capacity greater than 8 GB can be installed; however, the 9000Pro is capable of formatting only

up to a maximum 8 GB on the drive.

• Hard disk drives wider than 12.7 mm cannot be installed to the 9000Pro.

1-4

Use the same operation as in "Optional Plug-in Board Installation"

(page 16).

WARNING

• In order not to drop any screws inside the 9000Pro, keep the Plug-in Board and cover away from the 9000Pro

in the following steps #5 - #8.

If the Plug-in Board has been installed, pull out the cable connector from the Plug-in Board connector.

Remove the four screws from the Plug-in board/Hard disk

cover.

Turn over the Plug-in board/Hard disk cover.

Plug-in board stand

If a Plug-in Board (or boards) is installed, make sure to disconnect the Plug-in Board con-

nector(s) before continuing.

Hold the hard disk unit in place with your hand as shown below. Make

sure that the socket end of the unit faces toward you as shown.

This is the location for

the Hard disk unit.

Plug-in board/Hard disk cover

Hard disk unit:

top side face up

Turn over

Silver screws

(Bind head screw 3.0X4 MFNI33 (VG048000))

Plug-in board/Hard disk cover

Align the holes in the cover with the

holes on the hard disk. The actual

placement of the holes may differ

depending on the particular hard disk.