Yamaha AW4416 Supplément au manuel - Page 24

Parcourez en ligne ou téléchargez le pdf Supplément au manuel pour {nom_de_la_catégorie} Yamaha AW4416. Yamaha AW4416 48 pages. Installing an internal hard disk
Également pour Yamaha AW4416 : Manuel complémentaire (1 pages), Tutoriel (34 pages), Manuel complémentaire (20 pages), Manuel (3 pages)

Imprimer la page

QUICK REC screen

• You may connect the direct output of a channel to

more than one track. However you cannot connect

more than one direct output to the same track.

• A maximum of 16 patch cables can be connected. If

you have connected all 16, you will not be able to

further modify the routing unless you disconnect one

of the cables.

CURRENT/FLAT button

This button selects whether the corresponding

input channels will be reset to the default settings

when Quick Rec is executed. Move the cursor to

the button and press the [ENTER] key to switch

between the following two settings.

FLAT

When you execute Quick Rec, channel library 01

will be recalled to input channels to which an on-

screen patch cable is connected, restoring the

parameters to their default settings.

CURRENT

Input channel settings will not change when you

execute Quick Rec; only the patching will change.

REC.TR (Recorder tracks)

This column shows the connection status of tracks

1–16 (Tr 1–16). The

the left of this area indicates the input for each

track.

When you move the cursor to a jack symbol and

press the [ENTER] key, that track will be high-

lighted, indicating that it is selected for operations.

You can cancel the selection by pressing the

[ENTER] key once again.

ALL CLEAR button

This button clears all patch cable connections.

CLEAR buttons

These buttons clear the patch cable connected to

the corresponding track.

EXECUTE button

When you move the cursor to this button and

press the [ENTER] key, the patching settings speci-

ﬁed in the Quick Rec 2 page will take effect.

At this time, the input channels/tracks to which

patch cables are connected will change as fol-

lows.

• The input patch and recorder input settings will

change according to the settings of the Quick

Rec 2 page.

• Assignments to the stereo bus will be forcibly

cancelled for all input channels to which a

patch cable is connected.

• Channel library number 01 will be recalled for

each monitor channel of a track to which a

patch cable is connected, resetting it to the

default state.

• All corresponding tracks will be set to record-

ready mode.

(jack) symbol displayed at

Version 2.0 Manual Supplement

• If the CURRENT/FLAT button is set to FLAT, set-

tings will be initialized for all input channels to

which a patch cable is connected.

• Input channels/tracks (monitor channels) to which

no patch cable is connected in the Quick Rec 2 page

will not be affected in any way.

• When you access the Quick Rec 2 page, the settings

you made most recently will be displayed. However

if you manually modiﬁed the input patching or

recorder input patching in another screen, it is possi-

ble that the patch cable display will not match the

actual signal ﬂow.