Yamaha PORTATONE PSR-500M Manuel du propriétaire - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Yamaha PORTATONE PSR-500M. Yamaha PORTATONE PSR-500M 46 pages.
Imprimer la page
PREPARATION
This section contains information about setting up your PSR-
500M and preparing to play. Be sure to go through this section
carefully before using your PSR-500M.
Your PSR-500M will run either from the supplied power adaptor or optional
batteries*. Follow the instructions below according to the power source you intend
to use.
* When batteries are used the sound of the PSR-500M may be distorted at high volume levels.
This is because the power of the amplifier is reduced when batteries are used.
CAUTION!
Never interrupt the power supply (e.g. remove the batteries or unplug the AC adaptor) dur-
ing any PSR-500M record operation! Doing so can result in a loss of data.
Using the Supplied AC Power Adaptor
C
Plug the DC output cable from the supplied Yamaha PA-5 AC Power Adaptor
into the DC IN jack on the rear panel of the PSR-500M, then plug the AC cable of
oc 9 12V IN
the Power Adaptor into a convenient wall AC power socket.
;
The internal batteries are automatically disconnected when an AC Power Adap-
tor is used.
* Use ONLY a Yamaha PA-5 AC Power Adaptor to power your instrument from the AC mains.
Other adaptors may be damaged by use with the PSR-500M, and they may even cause
serious damage to your PSR-500M.
Using Batteries (sold separately)
cy
Six 1.5V SUM-1, "D" size, R-20 or equivalent batteries must first be installed in
the battery compartment, as follows:
1. Open the battery compartment cover located on the instruments bottom panel
and remove the old batteries.
2. Insert the six new batteries, being careful to follow the polarity markings on the
inside of the compartment.
3. Replace the compartment cover, making sure that it locks firmly in place.
When the batteries need to be replaced, "batt" will appear on the MULTI DIS-
PLAY. When this display appears the PSR-500M will not operate, and the power
must be turned off while either the batteries are replaced or an AC adaptor is con-
n
as
nected.* Internal data will be retained for up to about 10 minutes while the batter-
b а t t
ies are changed or an AC adaptor is connected.
* If fresh batteries or an AC adaptor are not immediately available, it may be possible to use
the PSR-500M for a little while longer by turning the power off and then on again, and play-
ing at a low volume setting.
Caution:
1. When the batteries run down, replace them with a complete set of six new batteries.
NEVER mix old and new batteries.
2. Do not use different kinds of batteries at the same time.
3. To prevent possible damage due to battery leakage, remove the batteries from the instru-
ment if itis not to be used for an extended period of time.