Avoid carpets in cool, dry areas.
o
Dissipate static electricity before handling any system components by touching a
o
grounded metal object.
If possible, use anti-static devices, such as wrist straps and floor mats.
o
Take care when installing the board. A damaged pin can render the board unusable.
o
Prevent damage to the connectors by aligning connector pins before you apply pressure.
o
A damaged pin can render the board unusable and can cause damage to system
components at power-on.
If disconnecting a cable, always pull on the cable connector, not on the cable itself.
o
Tools Required (SuperMAX installation NOT including battery holder)
Standard flat-head screwdriver (small).
o
Standard Philips screwdriver.
o
Condition of DX7
While the SuperMAX+ will replace the functionality of damaged or missing EPROM and/or SRAM
chips, it will not correct other problems your vintage synthesizer may have. It is recommended
that the synth be in otherwise good condition before beginning the installation. For instance, the
battery voltage should be checked and the battery replaced/repaired by a tech if necessary.
Sockets for the EPROM and SRAM chips should be in good working order and not be dirty,
oxidized, rusted or otherwise compromised.
SuperMAX+.
2: Installation
Back up your patches if they are important to you!
Open the DX7
Using a Philips head screwdriver, remove the 5 screws from the front panel. Two are located
on the left front. Two are located on the right front. A final one is located on the right rear. Set the
screws aside, noting that the rear panel one is the shortest.
DX7 SuperMAX+
If repair is required, do it before installing
Page 2 of 7
www.musictechnologiesgroup.com
Install
Imprimer la page