Yamaha YM-46 Manuel du propriétaire - Page 10
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Yamaha YM-46. Yamaha YM-46 19 pages. Concert marimbas
Également pour Yamaha YM-46 : Manuel du propriétaire (20 pages)
Imprimer la page
YM-460/460F/410/410F/46/41
ASSEMBLY
c
Attach the resonators.
3-1. Assemble the resonator pipes of the YM-460, 460F, 410, 410F, and 46. Make sure that the natural
tone and accidental tone sides are properly assembled. All pipes on the natural tone side have
bottoms attached.
3-2. Insert the resonators into the resonator holders on the frame ends in the same way as the rails.
Place the bass side of the resonators into the center grooves on the resonator holder.
* Make sure not to confuse the natural tone resonators and accidental tone resonators.
* Take care not to bump the resonators against the legs, etc.
* The resonators are factory adjusted so that the optimum resonance level is obtained at 23°C. If desirable
resonance is not available due to the temperature lower or higher than 23°C, adjust setting of the
resonators. Move the resonators to fit into longer grooves when the temperature is higher and into
shorter grooves when the temperature is lower.
Temperature
Higher
Around 23°C
Lower
30
Grooves to use
Short groove
("A" in the figure below)
Center groove ("B")
Long groove ("C")
A : For a higher temperature
B : For a temperature around 23°C
C : For a lower temperature
Resonators
(Accidental tone side)
Resonators
(Natural tone side)
Resonator holder