Yamaha YDP-C71PE Manuel du propriétaire - Page 28
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Yamaha YDP-C71PE. Yamaha YDP-C71PE 38 pages. Owner's manual
Imprimer la pageAppendix
Keyboard Stand Assembly
CAUTION
• Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accordance
with the sequence given below.
• Assembly should be carried out by at least two persons.
• Assemble the unit on a hard and flat floor with ample space.
• Be sure to use the correct screw size, as indicated below. Use of incorrect screws can cause damage.
• Be sure to tighten up all screws upon completing assembly of each unit.
• To disassemble, reverse the assembly sequence given below.
Have a Phillips-head (+) screwdriver of the
appropriate size ready.
Remove all parts from the package and make sure you
have all of the items.
D
Bundled pedal cord inside
Assembly Parts
1 6 20 mm long screws 4
2 6 16 mm short screws 4
3 4 12 mm thin screws 2
Headphone hanger set
6 4 10 mm thin screws 2
28
YDP-C71 Owner's Manual
A
E
B
C
AC Power cord
4 4 20 mm tapping screws 4
5 Cord holders 2
Headphone hanger
1
Attach (finger-tighten) C to D and E.
1-1 Untie and straighten out the bundled pedal cord.
Don't discard the vinyl tie. You will need it later in
step 6.
1-2 Align D and E with each end of C.
1-3 Attach D and E to C by finger-tightening the long
screws 1 (6 20mm).
1-2
E
C
1-3
2
Attach B.
2-1 Place the lower side of B on each foot of D and E,
then attach the upper side to D and E.
2-2 Attach the top of B to D and E by finger-tightening
the thin screws 3 (4 12mm).
2-3 While pushing the lower part of D and E from
outside, secure the bottom ends of B using two
tapping screws 4 (4 20mm).
2-4 Insert the other two tapping screws 4 (4 20mm)
into the other two screw holes to secure B.
D
1-1