Yamaha AP-U70 Manuel de configuration - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel de configuration pour {nom_de_la_catégorie} Yamaha AP-U70. Yamaha AP-U70 47 pages. Personal amplifier
Également pour Yamaha AP-U70 : Manuel d'entretien (46 pages)
Imprimer la page
CONNECTIONS
Connecting your computer
Audio from your computer can be fed to this unit using any of the following connectors: USB, DIGITAL PC COAX IN, DIGITAL
PC OPT IN, or ANALOG PC IN. If you use all of these connectors for connection, you can select the connector(s) to use on
this unit's front panel or the remote control.
Connecting to the USB port (1)
If your computer has a USB port, connect it to this unit's
USB terminal using the supplied USB cable, as shown
below.
A single USB connection is all that's required to listen to
audio from your computer on this unit, feed audio from an
external source connected to this unit to your computer,
and control this unit remotely from your computer, using
the supplied Application Software.
If your computer doesn't have a USB port, you can still
connect it to this unit using the analog or digital input, but in
this case you cannot use this unit's Application Software.
Note
Connect the USB cable when installing the USB driver software
on your computer. Refer to the section "INSTALLING USB
DRIVER AND APPLICATION SOFTWARE".
Connecting to analog inputs (2)
Connect the analog audio outputs on your computer or a
PC sound card to this unit's ANALOG PC IN.
Use a commercially available pin-plug connection cord for
connection, and be careful not to mix up the left and right
connections.
SUB
WOOFER
OUTPUT
4
E-
ANALOG
R
L
PC IN
AUX 1
IN
L
AUX 2
IN
R
REC
OUT
R
L
DIGITAL
USB
COAX
IN
PC
OPT
IN
AUX 1
OPT IN
OPT
OUT
Connecting to digital inputs (3)
To play DVD-Video discs encoded with Dolby Digital or
DTS, your computer must have a DVD-ROM drive and
DVD-Video decoder board, which should be connected to
this unit via the DIGITAL PC COAX IN or DIGITAL PC OPT
IN.
Use a commercially available pin-plug cord for connecting
to the DIGITAL PC COAX IN, and use a commercially
available optical fiber cable for connecting to the DIGITAL
PC OPT IN.
Note
The DIGITAL PC OPT IN has priority over the DIGITAL PC
COAX IN, so if you connect to both inputs, the signal received at
the DIGITAL PC OPT IN is used.
Protective Caps
When connecting to an optical connector, remove its protective
cap first. When an optical connector is not being used, replace its
cap to prevent dust entering the connector.
: Indicates the direction of signals.
LINE OUT
2
L
R
1
USB
DIGITAL
OUT
(coaxial)
3
3
DIGITAL
OUT
(optical)