Yamaha CinemaStation NX-SW150 Manuel du propriétaire - Page 9
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Yamaha CinemaStation NX-SW150. Yamaha CinemaStation NX-SW150 12 pages. Satellite speakers/ center speaker/ subwoofer
Imprimer la page
Notes
• One speaker weighs about 0.9 kg (2 lbs). To attach a speaker to a wall using screws, the wall must be firm. Do not attach a speaker to
a wall that is made of weak materials such as plaster or veneered woods. Doing so may cause the speaker to fall.
• Make sure you use specified screws to attach a speaker to a wall. Using clamps other than specified screws, such as short screws, nails,
or two-sided tape, may cause the speaker to fall.
• When connecting the speakers, fix the speaker cables in place so that cables do not loosen. If your foot or hand accidentally gets
caught on a loose speaker cable, the speaker may fall.
• After attaching each speaker, check that the speaker is fixed securely. YAMAHA will bear no responsibility for any accidents caused
by improper installations.
To mount on a speaker stand
60 mm (2-3/8")
YAMAHA speaker stand "SPS-80" (set of two, optional)
SPS-80
You can mount the speakers on YAMAHA speaker stands
"SPS-80" (set of two, optional) or commercially available
Mounting bracket
speaker stands. When using commercially available
(supplied)
speaker stands, follow the procedure below to attach the
supplied mounting bracket to the speaker. When using
YAMAHA speaker stands "SPS-80", you do not need the
following procedure.
For information on how to mount a speaker on the speaker
stand, refer to the manual for the speaker stand you want
to use.
1
Screw (supplied)
2
To mount a speaker on the YAMAHA speaker stand
"SPS-80", refer to manual for the speaker stand.
* This product may not be available in certain regions.
For information, contact the store where you purchased
the product or your nearest YAMAHA dealer.
Attach the mounting bracket to the speaker
using the supplied screw.
The jutting part of the bracket should fit to the groove
at the speaker base.
Mount the speaker on the speaker stand
using the holes on the mounting bracket.
To mount a speaker on a commercially available
speaker stand, you need two screws (Diameter: 4 mm
(5/32")), spring washers, and washers. For more
information, refer to the manual for the speaker stand
you want to use.
Placing the Speakers
5