Yamaha ESB-1090 Manuel du propriétaire - Page 28
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Yamaha ESB-1090. Yamaha ESB-1090 33 pages. Front surround system
Également pour Yamaha ESB-1090 : Manuel d'installation (4 pages), Manuel de démarrage rapide (40 pages), Manuel de démarrage rapide (8 pages)
Imprimer la page
[Automatic standby function]
You can use the automatic standby function (a function that
automatically turns off the power to the unit). When this function is
enabled, the unit turns off automatically in either of the following
conditions.
• Eight hours have passed without operation of the unit.
• 10 minutes have passed without operation of the unit and without
input of an audio signal to the unit.
The automatic standby function can be enabled/disabled by following
the procedure below.
1. Turn off the power to the unit.
2. Touch and hold the input source setting button on the touch
panel, and also touch the power button for at least 5 seconds.
The CLR VOICE indicator lights up when the unit is enabled from
disabled.
When going from enabled to disabled, none of the indicators will be
lit.
That's all for the procedure. When the switchover is complete, the unit will
turn on.
[Bluetooth standby function]
You can use the Bluetooth standby function (a function that allows you to
operate the unit with a Bluetooth device). When this function is enabled,
you can turn on the unit by following the steps below.
1. Enable the Bluetooth function of the Bluetooth device (already
paired).
A list of peripherals that can be connected is displayed on the
Bluetooth devices screen.
2. Select "ESB-1090 XXXXXX Bluetooth" (XXXXX depends on the
Bluetooth address) from the list.
That's all for the procedure. The unit will turn on.
The Bluetooth standby function can be enabled/disabled by following the
procedure below.
1. Turn off the power to the unit.
2. Press and hold SPORTS button on the remote control for at least 5
seconds.
The BLUETOOTH indicator lights up when the device is enabled from
disabled.
When going from enabled to disabled, none of the indicators will be
lit.
That's all for the procedure. When the switchover is complete, the unit will
turn on.
28