Directechs DB3 Manuel d'installation - Page 18

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Directechs DB3. Directechs DB3 19 pages. 2011 subaru outback - 403.subaru2 1.25
Également pour Directechs DB3 : Manuel d'installation (20 pages), Manuel d'installation (19 pages), Manuel d'installation (20 pages), Manuel d'installation (10 pages), Manuel d'instruction (17 pages)

Imprimer la page

Quick Reference Guide (customer copy)

Sending commands to your vehicle

Whether you want to remote start the engine, lock/unlock the doors or pop the trunk, there

are 3 possible ways you can send commands to your vehicle, using the:

• Factory remote.

• Aftermarket remote.

• Directed SmartStart application via your smartphone.

If applicable, you can also start the engine remotely by pressing the Lock button 3 times

quickly on your factory remote.

Vehicle takeover with Push-to-Start (PTS)

Close vehicle doors, hood, and trunk, then send the

Remote Start command to start the vehicle.

Unlock door(s) with factory remote, door handle, or

aftermarket remote.

Complete the following steps within 45 seconds or the vehicle will shut down.

Enter the vehicle, ensuring the factory remote is inside

with you.

Close the vehicle doors, then put the car and gear and

drive off..

* Icon and remote appearance may differ depending on the model purchased.

Pit stop/idle mode

The vehicle pit stop/idle mode feature is not available in this firmware.

403.HKRS03 1.03 2021 Kia K5 2.5L Turbo (Smart Key)

Remote Start Limitations

•Vehicle can be remote started with a 10 minutes runtime and cannot be modified.

•Vehicle must be locked and armed for at least 45 seconds before remote starting.

•The vehicles ignition has not been cycled for 4 days or more.

•The remote start system will not work in the following conditions:

•The ignition is on.

•The alarm system is triggered.

•The doors/hood are open.

•The transmission is not in Park (P).

•The vehicle battery voltage is too low.

•The service engine light is on.

Note: Any stored DTC code errors will prevent vehicle from remote starting.

(no visual lights on dash)

Press Remote

Start button*

List of available commands

Press Unlock on

either remote*

Note that the information below is for many Viper, Clifford, Python, Avital, Automate,

Autostart and AstroStart models. Icons and commands may differ depending on the model

and options purchased. Refer to your authorized installation center for more specific

information.

Button(s)

14:36

Enter vehicle

with remote

Ready to

drive off

* Press & hold for 5 seconds to activate the trunk release (optional).

* Icon and remote appearance may differ depending on the model purchased.

14:36

Actions

Press & hold for 1 second to lock.

Press & hold for 1 second to unlock.

Press & hold for 1 second to remote start.