aldes Ventergy IAQ-FSVS Manuel - Page 13

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} aldes Ventergy IAQ-FSVS. aldes Ventergy IAQ-FSVS 15 pages. Filtering supply ventilator accessory kits continuous supply

Imprimer la page

Page 4 | RDF Installation Supplement

For installations in which the fan is connected to a range hood, or if an exhaust grille connected to the fan is located near the cooking surface (as shown below),

METAL DUCT

RDF

CEILING

GRILLE

WITHIN 30"

30"

OF COOK

SURFACE USE

METAL DUCT

ONLY

Range Hood/Cooking Surface Warning

TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A RANGE-TOP GREASE FIRE, OBSERVE THE FOLLOWING:

1. Never leave surface units unattended at high settings. Boilovers cause smoking and greasy spillovers that may ignite.

Heat oils slowly on low or medium settings.

2. Always turn range hood ON when cooking at high heat or flambeing food.

3. Clean ventilating fans frequently. Grease should not be allowed to accumulate on fan or filter. Use proper pan size.

Always use cookware appropriate for the size of the surface element.

SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal tray, then turn off the burner. BE CAREFUL TO PREVENT

BURNS. If the flames do not go out immediately, EVACUATE AND CALL THE FIRE DEPARTMENT.

NEVER PICK UP A FLAMING PAN - You may be burned.

DO NOT USE WATER, including wet dishcloths or towels, because a violent steam explosion could result.

Use an extinguisher ONLY if:

1. You know you have a Class ABC extinguisher, and you already know how to operate it.

2. The fire is small and contained in the area where it started.

3. The fire department is being called.

4. You can fight the fire with your back to an exit.

Mechanical Supply Fans

Mechanical supply of outdoor air tends to reduce the

potential and frequency of backdrafting by reducing

the contributing negative pressures; however, due

to a multitude of factors, including the wide range

of exhausting appliances that may be present, the

effects of wind and building shape, the presence of

multiple chimneys, building leakage, and the use of

operable windows, no one can assure elimination of

backdraft conditions so long as atmospherically vented

combustion equipment is present in the home.

ALDES North America accepts no liability for backdraft conditions resulting from negative pressures. Nor does ALDES North America

make representation that blending supply ventilators (BVS) are adequate to prevent such occurrences.

be sure to observe the following safety warnings:

FLEXIBLE DUCT

RDF

CEILING

OVER

FLEXIBLE DUCT

ACCEPTABLE

30"

OR AS REQUIRED

BY LOCAL

BUILDING CODE

RDF 8-8 MAX

RDF 12-8IP*

*Designates Impedance Protection with alternate wiring of capacitor across auxiliary winding of motor.

Warning

TO REDUCE THE RISK OF FIRE, USE ONLY GALVANIZED STEEL

DUCTWORK WHEN REQUIRED TO USE METAL DUCT.

NOTE: If only rigid ducting is allowed, a metal sound attenuator

shall be installed between the fan and the range hood.

NOTE: If the fan is not connected to a range hood or a grille in the

vicinity of the cooking surface, other approved ducting may be used

as described in the "Duct Connections" section of basic instructions.

REPLACEMENT PARTS LIST (BASE MODELS)

Motor

Model

P/N

RDF 8-8IP*

86 561

86 562

RDF 12-8

86 562

Based on "Kitchen Fire Safety Tips" published by NFPA.

Impeller

Dimensions (mm)

P/N

133 x 42

86 172

133 x 45

86 172

180 x 35

86 179

180 x 35

86 170

Capacitor

Cap

4uF

10uF

5uF