Directed Directechs DB3 Manuel d'installation - Page 11

Connecting the module

Important!

Make all the required connections to the vehicle, as described in this guide, and double check to ensure everything is correct prior

to moving onto programming.

Warning!

To take advantage of advanced features, you must use DirectLink 4.5 (and higher) or the Directechs Mobile application.

Flashing a module using your computer:

1. Connect the interface module to your computer using the XKLoader2.

2. Go to www.directechs.com using Internet Explorer, and select the Flash Module button.

3. Follow the instructions to select your vehicle, installation type, and configure your options.

4. Once you have configured the firmware options, click on the FLASH button.

Flashing a module using your smartphone or tablet:

1. Connect the interface module to your XKLoader3.

2. Launch the Directechs Mobile app on your smartphone or tablet.

3. Select FLASH YOUR MODULE and follow the on screen instructions.

When the flashing operation is successful, you can proceed with the instructions below.

D2D installation

Recommended: Connect the 10-pin, 12-pin and 14-pin harnesses to the module, then

connect the 4-pin D2D harness.

W2W installation

If required: Connect the 10-pin and 12-pin harnesses to the module, then connect the 14-pin

harness to the module.

403.VW15 2.00 2020 Volkswagen Tiguan

(12-pin)

(D2D)

(10-pin)

(14-pin)

(12-pin)

(10-pin)

(14-pin)