Clark Synthesis TST329 Manuel d'installation - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Clark Synthesis TST329. Clark Synthesis TST329 20 pages. Platinum, gold, silver and all weather transducers
Également pour Clark Synthesis TST329 : Manuel complémentaire (4 pages), Manuel d'installation (8 pages), Fiche technique (1 pages), Manuel de l'acheteur (2 pages), Spécifications (1 pages), Manuel d'installation (20 pages)

Imprimer la page
Clark Synthesis TST329 Manuel d'installation

Installation: Overview

Installation Type: Unimount Bracket
Screws into the bottom of the mounting surface.
Requires access only to the bottom of the mounting
surface. Requires a flat or nearly flat mounting surface.
Minimum 4-1/2" vertical space required,
including 1/2" clearance between the
Transducer and the floor.
3/4"-thick
mounting
surface
Unimount
Bracket
Flat Washer
Lock Washer
Screw
Jam Nut (up)
Transducer Lead Wire
6
Tactile Sound Transducers
NEVER TIGHTEN
BY TURNING THE
TRANSDUCER.
MAKE SURE TO
TIGHTEN THE JAM
NUT AGAINST THE
TRANSDUCER'S
BRASS NUT
3/8"-16
Threaded Stud
Jam Nut (down)
Washers
Screw
Jam Nuts
Installation Type: Hanger Bolt
Screws into the bottom of the mounting surface (into a
5/16" drilled hole. Requires access only to the bottom
of the mounting surface.
Minimum 3-1/2" vertical space required,
including 1/2" clearance between the
Transducer and the floor.
Minimum
3/4"-thick
Transducer Lead Wire
Tip: Tighten
two Jam Nuts
against each
other to screw
in Hanger Bolt
using wrench.
Joist
(edge view)
Drill 5/16" hole
3/8"-16
Hanger Bolt
Jam Nut (down)
Jam Nut
www.clarksynthesis.com