Clark-Reliance Jerguson 360 Series Manuel d'installation, d'utilisation et d'entretien - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel d'installation, d'utilisation et d'entretien pour {nom_de_la_catégorie} Clark-Reliance Jerguson 360 Series. Clark-Reliance Jerguson 360 Series 12 pages. Safety ballcheck valves

Imprimer la page

Jerguson

360 Series

3. Install gland ring with bevel side up. Align gland follower over studs with bevel side down and press

flush onto gland. Place Belleville washers onto studs over gland follower, with first washer cupped

up and second washer cupped down, to form a diamond shape. Thread nuts onto studs and hand

tighten in "X" pattern until snug. Torque nuts in "X" pattern to 15-20 in-lb. Visually confirm gland

follower is level.

Gland Ring

4. Install Handle Back onto valve and cycle the stem several times. Leave valve handle in the closed

position.

5. Replace upstream seat, and seal. Place into valve body.

6. Clean new ball mechanism thoroughly and apply a thin film of molykote or equivalent grease. Install

the ball into the valve taking care to ensure the slot matches the stem engagement. The ball

mechanism will only slide on the stem in one way. If the valve handle is rotated to the run position

the retainer clip should be showing out of the process opening as shown.

16633 Foltz Parkway ● Strongsville, OH 44149 USA ● Telephone: +1 (440) 572-1500 ● Fax: +1 (440) 238-8828

Gland Follower

www.Jerguson.com ● [email protected]

Belleville Washers & Nuts

(Handle In Run Position)

IOM J500.36

2017.10

Retainer Clip