Directed Xpresskit DBALL-NISS08EU Manuel d'installation - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Directed Xpresskit DBALL-NISS08EU. Directed Xpresskit DBALL-NISS08EU 10 pages.

Imprimer la page

Platform: DBALL2

Firmware: NISS08EU

LED Diagnostics & Troubleshooting

LED

Status

Module Progra mming

Off

Solid red

Solid

Solid green for

Solid

green

3 seconds

x3 sec

Ex terna l Module Synchronisa tion

Flashes red,

red, then

Flashes

orange x 10

red, red,

orange

Active Ground W hile Running

Flashes green

Flashes

green

Flashes red &

orange

Flashes red

& orange

Flashes green

Flashes

quickly

green

D2D a nd W 2W Comma nds

Flashes orange

Flashes

orange

x 1

Flashes orange

Flashes

orange

x 2

Flashes orange

Flashes

orange

x 3

Description

Module has no power.

W aiting to begin the

programming sequence.

Module was successfully

programmed.

OBDII feature not supported.

GROUND OUT ON (GW R)

command received.

IGNITION ON command received.

START ON command received.

LOCK command received.

UNLOCK command received.

TRUNK command received.

Troubleshooting

Check the power connections.

Make sure that the CAN connections are correct and

press PTS to turn ignition ON.

Normal operation

Diagnostic data bus not detected. Some features are

not supported by SmartStart. This can be caused by

missing wire connections or module hardware limitation.

Refer to the wiring installation section to check the

connections.

Otherwise, the Ground W hile Running (status) signal

was lost or was never received by the module.

Commands can come from RF, D2D or W 2W .

Otherwise, the ignition signal was not received by the

module. In a W 2W install, it will show only if the ignition

input wire is used.

Otherwise, the start signal was not received by the

module. In a W 2W install, it will show only if the ignition

input wire is used.

If the bypass module fails to flash, it means the module

did not receive the signal. Commands can come from

RF, D2D or W 2W .

Rev.: 20200502

Page 9