Directed Xpresskit DBALL2 Manuel d'installation et de référence rapide - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel d'installation et de référence rapide pour {nom_de_la_catégorie} Directed Xpresskit DBALL2. Directed Xpresskit DBALL2 16 pages. Ford5 remote start ready (rsr) installation
Également pour Directed Xpresskit DBALL2 : Manuel d'installation (12 pages), Manuel d'installation (19 pages), Manuel d'installation (18 pages), Manuel (14 pages), Manuel d'installation (13 pages), Manuel d'installation (14 pages), Manuel d'installation (19 pages), Manuel d'installation (16 pages), Manuel d'installation (20 pages), Manuel d'installation (15 pages), Manuel d'installation (18 pages), Manuel d'installation (16 pages), Manuel d'installation (18 pages), Manuel d'installation (16 pages), Manuel (19 pages), Manuel d'installation (11 pages), Manuel d'installation (10 pages)

Imprimer la page

Directed Xpresskit DBALL2 Manuel d'installation et de référence rapide

Platform: DBALL2

Firmware: GM6

LED Diagnostics and Troubleshooting

LED

Description

Module Programming

Module has no power.

Off

Waiting for SW CAN detection.

Solid Red

Bypass was skipped (RXT mode)

Solid Orange

Module was successfully programed.

Solid green x 3

seconds

Module was successfully programed

Solid orange x

without bypass (RXT mode).

3 secs

Module was successfully programed

Solid green x2

with second CAN (OBDII pin 6 & 14)

1 second,

SmartStart DTC

Module was successfully programed

without bypass (RXT mode) with second

Solid orange x2

for 1 second

CAN (OBDII pin 6 & 14) SmartStart DTC

External module synchronization

OBDII feature not supported.

Flashes red,red,

then orange x 10

Active ground while running

GROUND OUT ON (GWR) command

Flashes green

received.

Flashes red

IGNITION ON command received.

and orange

Flashes green

START ON command received.

quickly

D2D and W2W commands

Flashes orange

LOCK command received.

x 1

Flashes orange

UNLOCK command received.

x 2

Flashes orange

TRUNK command received.

x 3

Flashes orange

AUX1 command received.

x 4

Flashes orange

AUX2 command received.

x 5

Troubleshooting

Make sure the D2D harness is conencted or that the 12 Volt is present between the

red and black wires. If the 12 Volt is present, the modukle may be defective.

Make sure SWCAN is properly connected and turn ignition ON.

Normal operation.

Diagnostic data bus not detected. Some features are not supported by SmartStart.

This can be caused by missing wire connections or module hardware limitation.

Refer to the wiring installation section to check the connections.

Otherwise, the Ground While Running (status) signal was lost or was never received

by the module. Commands can come from RF, D2D or W2W.

Otherwise, the ignition signal was not received by the

module.

Otherwise, the start signal was not received by the

module.

If the bypass module fails to flash, it means the module did not receive the signal.

Commands can come from RF, D2D or W2W.

Rev.: 20151221

Page 14

In a W2W install, it will

show only if the ignition

input wire is used.