Clarke 4500658 Instructions d'utilisation et d'entretien - Page 8
Parcourez en ligne ou téléchargez le pdf Instructions d'utilisation et d'entretien pour {nom_de_la_catégorie} Clarke 4500658. Clarke 4500658 17 pages. 18v cordless impact wrench
Imprimer la page
BATTERY CHARGING
The battery will have been shipped in a low charge state and will require
charging before first time use.
1. Press the battery release clip on
the front of the battery pack.
2. Slide the battery pack from the
impact wrench.
3. Plug the charger into a 230V
power supply and switch ON.
• The green POWER ON light will
illuminate to show the unit is
connected to the mains supply.
4. Insert the battery pack into the
battery charger, as shown, noting
that it will only fit one way.
• The red light will come on to
indicate the battery is charging.
• When charging is complete, the
red light will go off and the
green light will come on. The
battery pack can be
considered charged and be
removed. Charging time will be
dependant upon the initial state
of the battery.
• When charging a new battery pack, it may initially not accept full
charge. This is common & does not indicate a fault. It can be
recharged fully after it has been discharged a couple of times.
• If charging does not take place, ensure all connections are clean.
• In the event of both LED indicators flashing rapidly, it can be
assumed that either the battery has become too hot, in which case
it should be left to cool down, or that a battery cell has failed and
the battery should be replaced.
5. After charging, switch off and unplug the charger from the power supply.
6. Remove the battery pack from the charger and slide it back onto the
impact wrench until it clips into place.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
8