Clarke CAT52 Instructions d'utilisation et d'entretien - Page 8
Parcourez en ligne ou téléchargez le pdf Instructions d'utilisation et d'entretien pour {nom_de_la_catégorie} Clarke CAT52. Clarke CAT52 17 pages. 4” angle grinder
Également pour Clarke CAT52 : Manuel d'utilisation et d'entretien (6 pages)
Imprimer la page
FITTING THE GRINDING DISC
WARNING: ENSURE THE AIRLINE IS DISCONNECTED FROM THE TOOL.
WARNING: WHEN FITTING DISCS, ALWAYS INSPECT FOR DAMAGE ETC,
NEVER USE GRINDING DISCS IF THEY ARE CHIPPED OR CRACKED.
1. Remove the flange nut.
2. Fit the grinding disc, ensuring the
hole in the disc sits snugly over the
shoulder on the arbor.
3. Refit the flange nut, finger tight.
• Ensure the shoulder on the
flange nut fits inside the hole on
the grinding disc.
4. Using the wrenches supplied, fit the
wrench (without pins) onto the
grinder arbor to prevent it from
turning.
5. Fit the other wrench (with pins) into
the two holes in the flange nut.
Hold both wrenches firmly and
tighten by turning the wrench with
pins in a clockwise direction.
6. Remove the wrenches before use.
REPLACEMENT DISCS
• Replacement cutting discs are available from your Clarke dealer.
(Part number 6470700).
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
8