Clarke Contractor CON750 Instructions d'utilisation et d'entretien - Page 9
Parcourez en ligne ou téléchargez le pdf Instructions d'utilisation et d'entretien pour {nom_de_la_catégorie} Clarke Contractor CON750. Clarke Contractor CON750 20 pages. Contractor jigsaw
Également pour Clarke Contractor CON750 : Manuel d'utilisation et d'entretien (17 pages)
Imprimer la page
INSTALLING/CHANGING BLADES
1. Use only jigsaw blades with the
correct T-shank.
2. With the jigsaw disconnected from
the power supply, raise the blade
guard and press the blade retainer
to the right hand side.
3. Select the appropriate blade for
the job in hand, and insert it into
the blade holder as far as it will go,
with the teeth facing forwards.
4. Release the blade retainer, ensuring that the blade remains as far into the
retainer as it will go, pressing against the resistance of the internal spring.
5. Pull the blade to check that it is secure before restoring the power supply.
• Take care never to use cracked, blunt or damaged blades.
OPERATION
IMPORTANT: DO NOT plug in to the mains, unless you have ensured the jigsaw
is switched OFF. To do this, squeeze the trigger fully upwards, then release it.
The trigger is located under the grip.
1. Ensure that the workpiece being cut is securely held in place and that the
cut line is clearly marked.
2. Connect the vacuum extractor port to an extract system wherever
possible.
• The jigsaw is provided with a dust extract facility, where a vacuum
extractor may be connected to the rear of the machine. Please note
however, that this does not preclude the user from wearing a face mask
to prevent the inhalation of dust particles.
3. Place the sole-plate on the workpiece taking care that the blade is
vertical and correctly positioned in relation to the cut line without
touching it. Push the clear plastic blade guard down fully.
4. Ensure the blade is not striking on anything below the workpiece and that
the power cable is well away from the moving blade before starting the
saw.
• If cutting out an aperture, it will be necessary to drill a suitably sized hole in
the workpiece for use as a starting point.
• Note that the blade should emerge from the workpiece at every point of
the cut.
Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]
9