Clarke CPSB200B Manuel d'utilisation et d'entretien - Page 8
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Clarke CPSB200B. Clarke CPSB200B 17 pages. Pressurised sandblaster
Imprimer la page
ABRASIVE SELECTION
The type of abrasive you choose will greatly influence the amount of time
needed to clean a given surface area.
Suitable Abrasives available from your clarke stockist
Aluminium Oxide
Powder
Glass Bead Abrasive
Soda Blast Abrasive
Garnett Abrasive
LOADING THE ABRASIVE
• To prevent clogging, ensure that the abrasive you use is dry.
• While you may re-use abrasive but remember that abrasive grit/
material does wear out. After use, abrasive becomes smoother and
rounder, thus reducing its effectiveness.
NOTE: Re-using abrasive may also cause clogging due to fine debris
contained in the mixture from prior use.
1. Close the air supply valve by
turning it to the closed position,
see Fig 9.
2. Squeeze the trigger to release any
pressure from the tank.
• Make sure the pressure gauge
reads "0".
3. Remove the filler cap.
4. Using the sieve and funnel
supplied, pour the selected
abrasive material into the tank,
see Fig 10.
• Do not fill the tank more than
full.
• If humidity in your region is 90%
or more, only fill the tank
and check the water trap more
frequently.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
60
60-80
22kg
20kg
3052070 3052110 3052100 3052075 3052105 3052080
3052095 20kg
3052805 7.5kg
3052090 22kg
¾
½
full
8
60-80
80
7.5kg
22kg
3052800 22kg
Fig 9
80-120
120
7.5kg
22kg
Fig 10