Directed DBALL-GM10 XPRESSKIT Manuel de référence rapide - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel de référence rapide pour {nom_de_la_catégorie} Directed DBALL-GM10 XPRESSKIT. Directed DBALL-GM10 XPRESSKIT 16 pages.

Imprimer la page

Platform: DBALL

Firmware: GM10 v. 2.08+

Installation Type 2

Light Switch

Connector

(-) Parking Lights

Refer to the Vehicle

Wiring Reference Chart

(page 8) for wire color

and location.

OBDII

Diagnostic Connector

Pin 1

Pin 6

Pin 14

(-) Driver Door

Sense Trigger

(Gray/Black)**

Data Bypass, Pin 2

Cut

Immobilizer Control

Module (K89)

Not required in D2D mode.

* Tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D.

** If the RAP OFF wire is not connected, the radio will turn OFF but some lights will remain ON in the central console for 10 minutes. Connect this wire

(Green/Black, pin 2/12) to the driver door sense trigger (Gray/Black) to avoid the issue.

*** Use (-) Aux or any (-) trigger to activate the heated seats function during run time.

† Heated seat feature must be enable, see Feature Programming (page 12).

Wires are listed by pin numbers. This display is not representative of connector pin layouts, which are often stacked.

(-) Hood Status Input

(AC) Tach Input*

(-) Trunk Status Input

(-) Door Status Input

(-) Neutral Safety Input/(-) Handbrake Status Input*

(-) Ground

(+) 12 V

(-) Parking Lights

1: Light Green: Single Wire CAN

3:Tan/Black: HSCAN High

4:Tan: HSCAN Low

10: Orange/Red: Relay 2 NC

11: Yellow/Red: Relay 2 Com

12: Brown/Red: Relay 2 NO

(+) 12v

13: Red: (+) 12v

(-) Ground

14: Black: (-) Ground

1: Black/White: (-) Handbrake Status Output*

2: Green/Black: RAP OFF**

3: Green/White: (-) Door Status Output

4: Red/Black: (-) Trunk Status Output

5: Violet/White: (AC) Tach Output*

6: Gray: (+) Brake Output

7: Gray/Black: (+) Accessory Output

10: Yellow/Black: Data Bypass

11: Orange/Black: Data Bypass

12: Blue/Red: (-) Hood Status Output

Accessory, Pin 3

Ignition

Control

Switch

Ignition, Pin 1

(+) Brake Input

(-) Lock Output

(-) Unlock Output

(-) Ground

(-)Trunk Output

(+) 12 V

(-) Aux3***

(+) Starter Output

(+) Ignition Output

(-) GWR (Status)

Programming button

DBALL

LED

Refer to the Vehicle Wiring

Reference Chart (page 8)

for wire color and location.

Rev.: 20130304

Page 7

10: Blue/White: (-) GWR (Status) Input

8: Violet: (+) Starter Input

†

6: White/Black: (-) Heated Seats

3: Red/White: (-) Trunk Input

2: Blue: (-) Unlock Input

1: Green: (-) Lock Input

(+)12v

(-) Ground

XKD2D65