Directed Directechs DB3 Manuel d'installation - Page 12

Module programming

Refer to "LED diagnostics and troubleshooting" for more information and for troubleshooting purposes.

Wait until the LED turns ON solid red.

Note: To skip the transponder programming and use convenience features only, press

the programming button 5 times. When the LED turns ON solid orange, proceed to

step 2.

Press on the Push-to-Start (PTS) button twice to turn the ignition ON. The LED flashes

orange quickly for approximately 5 seconds, then flashes green. It may flash green for

25 seconds.

Note: If the LED flashes red 3 or 4 times after the initial 25 seconds, wait an extra 30

seconds.

If the transponder programming was skipped, the LED turns ON solid orange for 3

seconds then shuts OFF once the module is successfully programmed without

transponder.

If the LED starts flashing orange slowly, Key2GO programming will be required for

your vehicle.

Press the PTS button once more to turn the ignition OFF, remove the module from the

vehicle, and reconnect it to your computer. The web site will automatically recognize

that you are moving onto the second phase of the programming sequence. Proceed to

step 4.

If however, the LED turns ON solid green for 3 seconds, then shuts OFF, press the

PTS button once more to turn the ignition OFF. The programming sequence was

successfully completed.

Click on Submit Key2GO Request.

Once the configuration is completed, reconnect the module. The LED turns ON solid

green for 3 seconds, then shuts OFF.

You have successfully completed the module programming sequence.

403.HONDA9 1.12 2014 Acura RLX (Smart Key)