Directed Directechs DB3 Manuel d'installation - Page 5

Pre-installation and application warnings

This section highlights important information for this specific firmware and will assist in pricing accordingly, as

START

HERE

well as bringing awareness to any operational or vehicle limitations.

Compatibilities and Requirements

T-Harness

T-Harness is not compatible.

compatible

Vehicle Takeover

Firmware notes

"Keyless Starting Error" message: It is possible to get a "Keyless Starting Error" message when remote started. This message will

disappear when the vehicle is started with the key.

Potential error messages: Do not turn vehicle Ignition ON with any vehicle connectors disconnected, including during module

programming. Failure to do so may result with errors in the instrument cluster or hidden error messages.

Power liftgate and sliding door controls: These are only available when the engine is OFF (where applicable).

Key2GO: May be required if the interface does not program using the traditional method. Refer to "Module programming" for more

information.

Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic connector.

Refer to the "Vehicle connections" following the installation diagram.

Footnotes

[1] Hood pin: The installation of an aftermarket hood pin is only required on vehicles that are not equipped with a factory

hood pin, or if not supported in data..

[2] Tach:

The tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D.

403.HONDA7 2.43 2019 Honda CR-V

Refer to the Quick Reference Guide section for more details.

Keys required for

Keys required

programming

for operation