Zanussi ZBB5286 Manuel de l'utilisateur - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Zanussi ZBB5286. Zanussi ZBB5286 16 pages.

Imprimer la page

As the colours of the wires in the mains lead of this appli-

ance may not correspond with the coloured markings

identifying the terminals in your plug, proceed as follows:

1. Connect the wire coloured green and yellow to the

terminal marked either with the letter "E" or by the

earth symbol

or coloured green and yellow.

2. Connect the wire coloured blue to the terminal either

marked with the letter "N" or coloured black.

3. Connect the wire coloured brown to the terminal ei-

ther marked with the "L" or coloured red.

4. Check that no cut, or stray strands of wire is present

and the cord clamp

sheath.

5. Make sure the electricity supply voltage is the same

as that indicated on the appliance rating plate.

• Loosen the upper pin

and remove the spacer.

• Remove the upper pin

and the upper door.

Ventilation requirements

The airflow behind the ap-

pliance must be sufficient.

is secure over the outer

• Unscrew the pins (B)

and spacers (C).

min.

50 mm

200 cm

6. Switch on the appliance.

The appliance is supplied with a 13 amp plug fitted

In the event of having to change the fuse in the plug sup-

plied, a 13 amp ASTA approved (BS 1362) fuse must be

used.

Warning! A cut off plug inserted into a 13 amp

socket is a serious safety (shock) hazard. Ensure

that it is disposed of safely.

Door reversibility

The door of the appliance opens to the right. If you want to

open the door to the left, do these steps before you install

the appliance:

• Remove the lower door.

• Loosen the lower pin.

Installing the appliance

Caution! Make sure that the mains cable can move

freely.

Do the following steps:

min.

200 cm

On the opposite side:

• Install the lower pin.

• Install the lower door.

• Refit the pins (B) and the

spacers (C) on the mid-

dle hinge on the oppo-

site side.

• Install the upper door.

• Tighten the spacer and

tighten the upper pin.