Zanussi ZPC 726 D Livret d'instructions - Page 5

Parcourez en ligne ou téléchargez le pdf Livret d'instructions pour {nom_de_la_catégorie} Zanussi ZPC 726 D. Zanussi ZPC 726 D 9 pages.

Fitting door panels

Fig. 3

To fit the door panel, proceed as follows:

Loosen the screws fixing the side freme (Fig. 4);

loosen all the other screws fixing the door

freme; insert the panel from the side on which

the freme has been removed and push it

through; refit the freme on the door again and

tighten all the screws.

Note:

D151

The panel size should be 1-2 mm lower than

Fig. 4

the door; the maximum panel thickness should

be 4 mm.

The housing dimensions should be as follows:

Height 1446 mm

Minimum depth 550 mm

Fig. 5

Minimum width 560 mm

Cooling air comes in through the ventilation grid

at the bottom of the appliance. To ensure air

circulation, leave a ventilation gap at the back of

the appliance, having the following dimensions:

depth: 50 mm, width: 540 mm (Fig. 5).

A similar gap must also be left in the top of the

kitchen furniture.

Remove the two spacer bushes (A) then fit the

appliance into the recess in the tali kitchen unit.

Using the four screws supplied with the

appliance, secure the four corners of the

appliance cabinet hinge to the tali kitchen unit.

Before plugging in, ensure that the voltage and frequency shown on the serial number plate

correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For

operation with different voltages, a suitably sized auto-transformer must be used.

TECHNICAL SPECIFICATIONS

The technical data is indicated in the rating plate on the left side inside the appliance.