Zanussi ZPL 5165 Livret d'instructions - Page 5

Parcourez en ligne ou téléchargez le pdf Livret d'instructions pour {nom_de_la_catégorie} Zanussi ZPL 5165. Zanussi ZPL 5165 9 pages.

Imprimer la page

Left hand door opening

Remove the upper right screw and pivot.

Straighten the safety washer (4) of the lower right

hinge. Remove the screw (5) and the pivot (6)

(Fig. 3). For safety reasons bend the washer located

under the left hinge (Fig. 4), by using a tool (for ex.

a screwdriver). Remove the right door stop hinge

(3-Fig. 3).

D563

Fitting the handle

Holes for ﬁtting the handle on the opposite side are

provided, with ﬁxing screws already in place.

Inner door reversal

Using a screwdriver release bracket (1) by pressing

on the internal spring (Fig. 5) and withdraw it from

its seat together with the door;

remove plug (2) and ﬁt it in the hole left open on the

opposite side;

180°

PR140

To ensure correct storage of food, the door is ﬁtted

with a simple spring device which holds it in the

open position until it is properly closed.

Fig. 4

Fig. 5

turn the door

through 180 ,

remove the

bracket (1) and

reﬁt it on the

opposite side.

Reﬁt the door and

insert the top pin

and bottom

bracket (1),

pushing it into

place.

Building-in

Recess dimensions

ZPL 5233

Height

1225 mm

Depth

550 mm

Width

560 mm

For safety reasons, minimum ventilation must be as

shown in Fig. 6.

Attention: keep ventilation openings clear of obstruction.

50 mm

D567

Air is taken in through the ventilation grille at the

bottom of the appliance, but an air outlet "gap",

measuring 50 mm deep by 540 mm wide (Fig. 7),

must be provided in the rear of the kitchen unit.

This outlet gap must also be kept clear between the

top of the unit and the ceiling.

Slide the refrigerator into the unit recess and ﬁt the

screws into the top bracket (Fig. 8) and into the

bottom hinge (Fig. 8).

D240

D585

Fig. 6

min.

200

Fig. 7

Fig. 8