Zanussi ZRB34NA Manuel d'instruction - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Zanussi ZRB34NA. Zanussi ZRB34NA 17 pages. Refrigerator-freezer combination

Imprimer la page

The appliance and environment

This appliance does not contain gases which could dam-

age the ozone layer, in either its refrigerant circuit or insu-

lation materials. The appliance shall not be discarded

together with the urban refuse and rubbish. Avoid damag-

ing the cooling unit, especially at the rear near the heat

exchanger. Information on your local disposal sites may

be obtained from your municipal authorities.

The materials used on this appliance marked with the

sympol

are recyclable.

Maintenance

Defrosting

Bleeding part of the moisture of cooling chambers in

form of frost and ice goes with the operation of the appli-

ance.

Thick frost and ice has an insulating effect, so it reduces

cooling efficiency as the temperature increases in the

cooling chambers, they need more energy.

At this type of appliance defrosting the cooling surface of

the refrigerator is automatic without any external interven-

tion.The thermostatic control interrupts the operation of

compressor at regular intervals for more or less time -

during this cooling is interrupted - the temperature of the

cooling surface goes above 0°C due to interior heating

load of the compartment, so defrosting occurs. When the

surface temperature of the cooling surface has reached

+3 - +4 °C the thermostatic control restarts operation of

the system.

Melting water flows through defrost water outlet leaded

through the back into the evaporator tray maintained on

the top of compressor and evaporates due to its warmth.

Check and clean the outlet of melting water

coming during defrosting regularly - a label

inside the appliance warns you for this. If it is

clogged the melting water gathered can cause earli-

er failure as it can go to the insulating of the appli-

ance.

Clean the melting water outlet with the supplied pipe scraper

that can be seen in the figure. The pipe scraper has to be

stored in the outlet.

The most typical case of clogging up in the melting water out-

let when you put food wrapped in some paper into the appli-

ance and this paper contacts back plate of the refrigerator and

freezes to it. If you remove the food right at this moment the

paper will tear and it can cause clogging up in the outlet by get-

ting into it. So you are asked to be careful - because of the

above - when placing foods wrapped in paper into the appli-

ance.

In case of increased demand e.g. during heatwaves,

the refrigerator temporarily happens to operate con-

stantly - during this the automatic defrosting does not work.

Remaining small ice and frost stains on back plate of the refrig-

erator after defrosting period is not abnormal.

The freezer can not be equipped with automatic defrosting set

since the deep-frozen and frozen foods do not endure melting

temperature.

When small frost and ice occurs scrape off and remove frost

and ice coating with the supplied plastic scraper.

When ice coating is so thick that it cannot be removed with the

plastic scraper, the cooling gill have to be defrosted.

Frequency of defrosting depends on usage (generally 2-3

times a year).

Take the frozen foods out of the appliance, and put them into

a basket lined with paper or cloth. Store them in a possibly

cool place or replace them into another refrigerator.

Pull out the mains plug from the mains socket, so both parts

of the appliance are out of operation.

Open the doors of both parts of the appliance and clean the

refrigerator according to 'Regular cleaning'. Maintain and

clean the freezer as following:

Sweep off the melting water with a cloth or sponge in direction

of sides of the cooling plates. The melting water swept down

gathers in the outlet channel practically formed in the bottom

of the appliance and can be removed according to figure.

Put an adequately high bowl or dish under the outlet.

The bowl in figure is not a piece of accessories to the appli-

ance!

Wipe the surfaces after defrosting and leading the water out,

bend the plastic outlet back and fix it.

Put the mains plug into the mains socket and put foods taken

out back to their places.

It is recommended to operate the appliance at the highest posi-

tion of the thermostatic control for some hours so that it can

reach the sufficient storing temperature as soon as possible.