Zanussi ZRW106N Manuel de l'utilisateur - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Zanussi ZRW106N. Zanussi ZRW106N 16 pages. Wine refrigerator
Imprimer la page
•
Under no circumstances should you attempt to
repair the appliance yourself. Repairs carried out by
inexperienced persons may cause injury or more
serious malfunctioning. Refer to your local Service
Centre, and always insist on genuine spare parts.
•
This appliance contains hydrocarbons in its cooling
unit; maintenance and recharging must therefore
only be carried out by authorized technicians.
Use
•
The domestic wine refrigerator is designed to be
used specifically for the storage of potable wine only.
•
Best performance is obtained with ambient
temperature as follows:
Climate class
SN
+10 °C to +32 °C
N
+16 °C to +32 °C
ST
+16 °C to +38 °C
T
+16 °C to +43 °C
The class of your appliance is shown on its rating plate.
•
Warning:
when the ambient temperature is not
included within the range indicated for the class of
this appliance, the following instructions must be
observed: when the ambient temperature rises up
the maximum level, the storage temperature in the
refrigerator cannot be guaranteed, it is advisable to
use the food stored as soon as possible.
•
Do not put hot pot on the plastic parts of the
appliance.
•
Do not store flammable gas and liquid in the
appliance, because they may explode.
•
Do not place wine directly against the real wall of
compartment.
•
The appliance's manufactures storage
recommendations should be strictly adhered to.
Ambient temperature
Refer to relevant instructions.
•
The inner lining of the appliance consists channels
through which the refrigerant passes. If these should
be punctured this would damage the appliance
beyond repair and cause food loss. DO NOT USE
SHARP INSTRUMENTS to scrape of frost or ice.
Frost may be removed by using a scraper. Under
no circumstances should be solid ice be forced off
the liner. Solid ice should be allowed to thaw when
defrosting the appliance.
Installation
Important: For electrical connection carefully follow
the instructions given in specific paragraphs.
•
Unpack the appliance and check if there are damages
on it. Do not connect the appliance if it is damaged.
Report possible damages immediately to the place
you bought it. In that case retain packing.
•
During normal operation, the compressor and/
or condenser at the back of the appliance heat
up considerably. For safety reasons, minimum
ventilation must be as shown in the instructions.
Attention: keep ventilation openings clear of
obstruction.
•
Care must be taken to ensure that the appliance does
not stand on the electrical supply cable.
Important: if the supply cord is damaged, it must
be replaced by a special cord or assembly available
from the manufacture or its service agent.
•
If the appliance is transported horizontally, it is
possible that the oil contained in the compressor
flows in the refrigerant circuit. It is advisable to wait
at least two hours before connecting the appliance to
allow the oil to flow back in the compressor.
•
There are working parts in this product which heat
up. Always ensure that there is adequate ventilation
as a failure to do this will result in component failure
and possible loss. See installation instructions.
•
Parts which heat up should not be exposed. Wherever
possible the back of the product should be against a
wall.
5