Zanussi ZTAN24FW0 Manuel de l'utilisateur - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Zanussi ZTAN24FW0. Zanussi ZTAN24FW0 21 pages.
Également pour Zanussi ZTAN24FW0 : Manuel de l'utilisateur (21 pages)

Zanussi ZTAN24FW0 Manuel de l'utilisateur
2. Connect the wire coloured blue to the terminal
either marked with the letter "N" or coloured
black.
3. Connect the wire coloured brown to the
terminal either marked with the "L" or coloured
red.
4. Check that no cut, or stray strands of wire is
present and the cord clamp (E) is secure over
the outer sheath.
Make sure the electricity supply voltage is the
same as that indicated on the appliance rating
plate.
5. Switch on the appliance.
The appliance is supplied with a 13 amp fuse (B).
In the event of having to change the fuse in the plug
supplied, a 13 amp ASTA approved (BS 1362)
fuse must be used.
WARNING! A cut off plug inserted
into a 13 amp socket is a serious
safety (shock) hazard. Ensure that it is
disposed of safely.
REAR SPACERS
In the bag with the documentation, there are two
spacers which must be fitted as shown in the
figure.

DOOR REVERSIBILITY

WARNING! Before carrying out any
operations, remove the plug from the
power socket.
Empty the appliance.
1. Make sure the appliance stands upright.
8
2. Open both doors and remove the door
equipment. Refer to "Daily Use" chapter. Close
the doors.
3. Use a thin-blade screwdriver to remove the
screw hole cover (A) and the upper hinge
cover (B). Put them aside.
A
4. Unscrew the screws of the right upper hinge.
Support the upper door with your hand.
Remove the upper hinge, reverse it, screw the
screws and the pin to it. Put the hinge aside.
1
5. Carefully lift the upper door from the middle
hinge to remove it. Place the upper door on the
soft surface. Be careful not to lose washers
that may stick to the door.
6. Unscrew the screw (B) and the "stop block" (A)
and screw them on the opposite side of the
door.
A
B
7. Unscrew the screws from the middle hinge.
Remove the middle hinge and put it aside
together with the screws.
B
2
3
1
3
2