Zanussi BMS 641 A Livret d'instructions - Page 17

Parcourez en ligne ou téléchargez le pdf Livret d'instructions pour {nom_de_la_catégorie} Zanussi BMS 641 A. Zanussi BMS 641 A 21 pages. Electric oven
Également pour Zanussi BMS 641 A : Livret d'instructions (21 pages), Livret d'instructions (21 pages)

Imprimer la page

Grease Filter (Fig. 12 Page 3)

To prevent a build-up of fats on the fan impellor, the

grease filter must be fitted by clipping it over the vents

in the back panel.

To clean the grease filter

When the oven has cooled down, remove the filter by

pushing the protruding tongue on the filter upward, and

wash carefully.

The grease filter should be cleaned after every use. The

filter may be washed in a dishwasher on a 65 C wash.

If the filter is heavily soiled, place the filter in a saucepan

of water with approximately 1 teaspoon of automatic

washing powder or dishwasher powder. Bring to the boil

and leave to soak for approximately 30 minutes or

longer depending on the degree of soiling. Ensure the

solution does not boil over as it could mark your hob.

Rinse filter in clear water and dry.

Remember to refit the filter before using the oven again.

Replacing the Oven Light (Fig.13 Page 4)

If the oven bulb needs replacing, it must comply with the

following specifications:

- Electric power: 25W,

- Electric rate: 220-240 V (50 Hz),

- Resistant to temperatures of 300 C,

- Connection type: E14.

These bulbs are available from your local Zanussi

Force Service Centre.

To replace the faulty bulb:

1. Ensure the oven is isolated from the electrical supply.

2. Turn the glass cover anticlockwise.

3. Remove the faulty bulb and replace with the new one.

4. Refit the glass cover.

5. Restore the electrical supply.

Cleaning the hinged grill

This model has been fitted with a hinged grill element to

enable you to clean the roof of the oven easily.

Before proceeding ensure the oven is

isolated from the electricity supply.

1) Undo the screw which holds the grill in place (see

Fig.10 Page 3).

2) Then gently pull the grill downward to allow access

to the oven roof (see Fig. 11 Page 3).

3) Clean the oven roof with a suitable cleaner and wipe

dry before replacing the hinged grill element.

4) Gently push up the grill element into place and firmly

screw into place the holding nut.

NOTE: Ensure the grill holding nut is

firmly in place to avoid the grill falling

down during operation.