Clarke X-Pro CAT213 Instructions d'utilisation et d'entretien - Page 7
Parcourez en ligne ou téléchargez le pdf Instructions d'utilisation et d'entretien pour {nom_de_la_catégorie} Clarke X-Pro CAT213. Clarke X-Pro CAT213 17 pages. Air nibbler
Imprimer la page
The minimum hose diameter should be 5/16"(8mm) ID and fittings should have
the same internal dimensions.
Never exceed the maximum operating pressure for the tool. It is
recommended that air pressure to this tool does not exceed 90 psi (6.2 bar) at
the tool when running. Higher pressures and unclean air will shorten the life of
the tool due to faster wear and is a possible safety hazard.
Use only clean, dry, regulated compressed air as a power source.
Air compressors used with the tool must comply with the appropriate
European Community Safety Directives.
A build-up of moisture or oil in the air compressor will accelerate wear and
corrosion in the tool. ensure any moisture is drained from the compressor daily
and the inlet filter is kept clean.
If an unusually long air hose is required, (over 8 metres), the line pressure or the
hose inside diameter may need to be increased.
The air hose must be rated at least 150% of the maximum operating pressure of
the air tool.
ACCESSORIES
A wide range of accessories is available including filter/regulators, lubricators,
high-pressure hoses (5 to 50 metres) etc.
Contact your CLARKE dealer for further information or CLARKE International
Service Department on 01992 565333.
CLARKE Air Line Oil (part no. 3050825) is available from your CLARKE dealer.
7
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]