Zanussi 132985450 Livret d'instructions - Page 9
Parcourez en ligne ou téléchargez le pdf Livret d'instructions pour {nom_de_la_catégorie} Zanussi 132985450. Zanussi 132985450 30 pages. Zanussi washing machine instruction booklet
Imprimer la page
132985450.qxd
18/07/2005
17:47
The
(D
) pilot light indicates if during the
OOR
washing cycle the door can be opened:
• Light on: the door can be opened
(when the washing machine is set to PAUSE, the
(D
) pilot light will go off).
OOR
• Light off: the door cannot be opened
(when the washing machine is set to PAUSE, the
(D
) pilot light will start to flash)
OOR
The
(
) pilot light flashes in the event of
END
operating problems and the corresponding alarm code
appears on the display.
= the machine does not fill
E E 1 1 0 0
= the machine does not empty
E E 2 2 0 0
= the door has not been closed
E E 4 4 0 0
To eliminate the problem, see paragraph "Something not
working".
If the
(
FILTER CLOGGED
end of the programme this means that the drain filter
must be cleaned.
14 Programme selector dial
The selector is divided into 5 sections:
• C
,
OTTON
• S
YNTHETICS
• D
ELICATES
• W
(hand washing)
OOL
• Special programmes
• Reset programme X
E
The selector dial can be turned either clockwise or
anticlockwise.
Position E corresponds to the ENERGY SAVING
programmes and position
At the end of the programme the selector dial must
be turned to position X (reset).
Pagina
9
) pilot light flashes at the
E
E
to "cold wash".
Functions
End of programme
When the
(
) pilot light on the programme
END
progress display illuminates, if the
light has gone out, the the door can be opened (if the
(
) option has not been selected).
RINSE HOLD
Turn the programme selector dial to X.
Switch the machine off by depressing the ON/OFF
button before removing the laundry.
Altering an option or a running programme
It is possible to change any option before the
programme carries it out.
Before you make any change, you must pause the
washing machine by pressing the START PAUSE
button.
Changing a running programme is possible only by
resetting it. Turn the programme selector dial to "X" and
then to the new programme position. The washing water
in the tub will not emptied out .
Start the new programme by depressing the START
PAUSE button.
Interrupting a programme
Depress the START PAUSE button to interrupt a
programme which is running: the corresponding light
starts to flash.
Depress the same button to restart the programme.
Opening the door after the programme has
started
You can open the door, after having set the washing
machine to PAUSE, provided the following conditions
exist:
• the washing machine has not heated beyond 55°C;
• the level of the water is not high;
• the drum is not turning.
If these requirements are met, the
will be on and, when you pause the washing machine, it
will goes out: the door can be opened.
Should it not be possible to open the door, and should it
be absolutely necessary to do so, switch the machine off
by pressing the ON/OFF button.
After approximately 3 minutes, you can open the door.
Pay attention to the level and temperatures of the
water in the washing machine!
When you close the door and press the ON/OFF button
again, the washing machine will resume the programme
from the point where it had been interrupted.
9
(D
) pilot
OOR
(D
) pilot light
OOR