Zanussi FAE1025V Manuel du propriétaire - Page 10
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Zanussi FAE1025V. Zanussi FAE1025V 48 pages. Zanussi washing machine
Également pour Zanussi FAE1025V : Manuel de l'utilisateur (27 pages), Manuel de l'utilisateur (4 pages)
Use
Control panel
1. Detergent dispenser drawer
Programme option buttons
Depending on the programme, different option
buttons can be combined.
When these buttons are pressed, the corresponding
lights come on. When they are pressed again, the
lights go off.
If an incompatible option with the selected
programme has been chosen, the corresponding
light flashes for about 2 seconds.
The option buttons:
PRE-WASH or
ECONOMY,
RINSE HOLD must be selected after the
required programme has been chosen, by turning
the programme selector (see section 9) and before
starting the machine, by pressing button
/ PAUSE.
2.
PRE-WASH or
By pressing this button you have the possibility of
choosing between the following options:
•
PRE-WASH option: Adds a pre-wash phase
at the start of the cycle with water heating to 30° C.
In COTTON and SYNTHETIC cycles, performs a
short spin before passing to the washing phase.
This option cannot be selected for WOOL.
•
QUICK WASH option: Using this option, you
can get good washing results in a short period of
time, since with option, the COTTON,
SYNTHETICS, and DELICATES programmes are
modified in order to obtain short washing times
(recommended for small or lightly-soiled loads).
This modification consists of reducing the number of
rinse cycles (one less) and also increases the water
level used in the remaining two rinse cycles.
If both lights (
PRE-WASH and
WASH) are not illuminated the programme will run
without either
PRE-WASH or
1
2
QUICK WASH;
SUPER RINSE and
QUICK WASH
QUICK
QUICK WASH).
3
4
5
6
7
3.
ECONOMY button
This option is available for COTTON programmes
(excluded D and F) and SYNTHETICS programmes
(excluded H and J). By selecting this button the
washing machine changes the washing phase
behaviour to have a cycle with better energy
performance (energy label cycle for cotton 60°) with
a longer cycle time.
4.
SUPER RINSE button
Can be used with all programmes, except wool.
The machine will add 2 rinses to the selected
programme.
This option is recommended for people who are
allergic to detergents and in areas where the water
is very soft.
5.
RINSE HOLD button
START
By selecting this button the water of the last rinse is
not drained. When the programme has finished the
light
END goes on. Before opening the door the
water must be drained.
6.
START / PAUSE button
After selecting the required programme, by the
programme selector (see section 9), press this
button to start the machine; the corresponding light
stops flashing and will keep lighting until the
programme finishes.
To interrupt the running programme, depress
START / PAUSE button: the corresponding
light starts to flash.
To restart the programme from the point at which it
was interrupted, press
again.
10
8
9
START / PAUSE button