Zanussi FCS 825 C Manuel de l'utilisateur - Page 12
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Zanussi FCS 825 C. Zanussi FCS 825 C 44 pages. Front-loading washing machine
Également pour Zanussi FCS 825 C : Manuel de l'utilisateur (48 pages)
Imprimer la page
• The drum should be empty of laundry.
• Select the hottest cotton wash programme.
• Use a normal measure of detergent, must be
a powder with biological properties.
External cleaning
Clean the exterior cabinet of the appliance with
soap and water only, and then dry thoroughly.
Cleaning the dispenser drawer
The washing powder and additive dispenser
drawer should be cleaned regularly.
When you put it back, press it downwards until
you hear a distinct click.
Cleaning the drawer recess
12
If necessary, the
whole detergent
drawer can be taken
out of the machine for
cleaning. You need to
pull it firmly outwards,
so that it comes free
of retaining stop.
To remove the siphon
at the inside edge of
the drawer for clean-
ing, you need to press
it inwards and pull it
upwards at the same
time. Flush it out un-
der a tap, to remove
any traces of accu-
mulated powder.
Having removed the
drawer, use a small
brush to clean the re-
cess, ensuring that all
washing powder resi-
due is removed from
the upper and lower
part of the recess.
Replace the drawer and run the rinse pro-
gramme without any clothes in the drum.
Cleaning the water inlet filter
If your water is very hard or contains traces of
lime deposit, the water inlet filter may become
clogged. It is therefore a good idea to clean it
from time to time.
The dangers of freezing
If the machine is exposed to temperatures be-
low 0°C, certain precautions should be taken.
• Turn off the water supply.
• Unscrew the inlet hose from the supply tap.
• Select a wash programme, start the machine
and let the programme run for a short time.
• Interrupt the programme by turning the pro-
gramme selector to
• Place the end of inlet and drain hoses down
low, into the waste gully (floor drain) set into
the floor. Make sure that the end of the hose
does not go below the water level in the gul-
ly's (drain's) water tap.
• Select the programme "Drain" and let it run
until it is finished.
• Turn the programme selector to
When you intend to start the machine up
again, make sure that the room temperature is
above 0 °C.
The appliance is only to be used and stored in-
doors at normal room temperature. The manu-
facturer is not responsible for any frost damage.
Turn off the water tap.
Unscrew the water in-
let hose. Clean the fil-
ter using a hard bris-
tle brush. Tighten up
the inlet hose.
position.
position.
www.zanussi.com