Zanussi FE 1004/6 Manuel de l'utilisateur - Page 15

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Zanussi FE 1004/6. Zanussi FE 1004/6 22 pages.

7. Select the desired options
If your laundry is very dirty, it may be advisable to
select the PREWASH option
Select the ECONOMY option
lightly or normally soiled.
If you wish to reduce the spin, select the SPIN
SPEED REDUCTION option
illuminates.
Press the OPTIONS button so as to cause one light
to light up.
8. Select the DELAY START option
To delay starting of a programme, press the DELAY
START button
, before starting the machine, until
the light corresponding to the required delay
illuminates.
12 h
8 h
6 h
4 h
2 h
9. Start the programme
Press the START/PAUSE button
light will stop flashing and only the light relevant to
the phase that is in progress will remain lit.
If you have selected the DELAY START, the machine
starts its hourly countdown.
.
, if your laundry is
. The relevant light
. The relevant
15
10. How to change a programme
during its cycle
Before you make any change, you must pause the
washing machine by pressing the START/PAUSE
button.
It is possible to change any phase before the
programme carries it out.
Changing the type of fabric or temperature is
possible, obviously, only during the washing phase.
When you make a change in these two parameters,
the washing machine will resume the cycle from the
beginning.
If it is necessary to drain the water in order to
change the programme in progress, proceed as
follows:
• PAUSE the machine by pressing the
START/PAUSE button;
• press the RESET button
only the DRAIN light
• press the START/PAUSE button again.
When the water has been drained, you may select a
new programme and press the START/PAUSE
button to start it.
11. How to cancel a programme
during its cycle
To cancel a programme that is being carried out,
first pause the washing machine by pressing the
START/PAUSE button, then press the RESET button
repeatedly, until all the phase indicator lights go out.
12. How to open the door during
a programme
You can open the door, after having set the washing
machine to PAUSE, provided the following
conditions exist:
• the washing machine is not in the heating phase
beyond 55°C;
• the level of the water is not high;
• the drum is not turning.
If these requirements are met, when you pause the
washing machine and the door can be opened.
Should it not be possible to open the door, and
should it be absolutely necessary to do so, switch
the machine off by pressing the ON/OFF button.
After approximately 3 minutes, you can open the
door.
repeatedly, until
remains lit;