Zanussi FJ1224/A Livret d'instructions - Page 8
Parcourez en ligne ou téléchargez le pdf Livret d'instructions pour {nom_de_la_catégorie} Zanussi FJ1224/A. Zanussi FJ1224/A 37 pages. Zanussi washing machine instruction manual
Également pour Zanussi FJ1224/A : Livret d'instructions (36 pages)
Imprimer la page
INSTALLATION INSTRUCTIONS
Your new Zanussi washing
machine has been designed to
be permanently plumbed in to
your home's water supply and
drainage
system.
How-
ever, if this is not possible, it
may be connected to suitable
existing taps, with the drain
hose discharging into a sink.
The appliance has two inlet
valves,
hot and
cold, with
female
3/4"
BSP
thread
connectors. If this connection
size is not compatible with the
plumbing
of the
existing
installation,
a variety
of
connectors are available from
good
hardware
stores
and
plumbers merchants
to suit
most domestic plumbing. Any
alterations to your existing
plumbing must be carried out
by a competent
person,
or
qualified plumber.
The inlets on the back of the
appliance
are colour coded,
blue for cold, red for hot.
Before connecting the hoses
be sure to fit the mesh filters
supplied as per diagram.
If only a eold water supply is
available,
connect
the
two
hoses to a cold water outlet by
means
of a «Y» connection
piece.
Installation should comply
with local water authority and
building
regulations'
requirements.
The appliance must be given
a separate cold water supply
and not be connected
to a
mixer tap, a single outlet water
heater or a booster pump. A
minimum water pressure of 7
psi is required
for
safe
operation of the appliance.
If you cannot make the cold
water connection direct from
the rising mains, you may be
able to operate the appliance
from your cold water storage
system.
There should be a minimum
distance of 5.02 m (16/2 ft)
between the appliance's inlet
and the bottom of the tank.
There
will be
sufficient
pressure for the hot water
supply from the hot water
cylinder if the height between
the appliance's inlet and the
bottom
of the
cold water
storage cistern (not between
the appliance and hot water
cylinder) is at least 2.74 m (9 ft).
Set the hose correctly by
loosening the ring nut. After
positioning the inlet hose, be
sure to tighten the. ring nut
again to prevent leaks.