Zanussi FL1018 Livret d'instructions - Page 17

Parcourez en ligne ou téléchargez le pdf Livret d'instructions pour {nom_de_la_catégorie} Zanussi FL1018. Zanussi FL1018 24 pages. Washing machine fl1018

Imprimer la page

7. Select the DELAY START

(ARRANQUE RETARDADO)

Before you start the programme, if you wish the

starting to be delayed, press the DELAY START

button repeatedly, to select the desired delay. The

relevant light illuminates.

8. Start the programme

To start the selected programme, press the

START/PAUSE (INICIO/PAUSA) button; the

corresponding light stops flashing.

The FUNCIÓN (WASHING) light illuminates.

The machine starts operating.

If you have chosen a delayed start, the machine will

begin the countdown.

9. Altering a programme

You can alter the programme before it starts.

When the programme has started, you can only

reset it by turning the programme selector dial to O

and then you can select the new programme.

The washing water remains in the tub.

Start the new programme by depressing the

START/PAUSE button.

10. Interrupting a programme

Depress the START/PAUSE button to interrupt a

programme which is running, the corresponding light

starts to flash. Depress the button again to restart the

programme.

11. Cancelling a programme

Turn the selector dial to O to cancel a programme

which is running. Now you can select a new

programme.

12. Opening the door after the

programme has started

First set the machine to PAUSE by pressing the

START/PAUSE button.

If the door does not open in 2 minutes, this means

that the machine is already heating, that the water

level is above the bottom edge of the door or that the

drum is turning.

If you cannot open the door but you need to open it

you have to switch the machine off by turning the

selector dial to "O". After about 3 minutes the door can

be opened (pay attention to the water level and

temperature!).

13. At the end of the programme

The machine stops automatically.

If the AGUA EN LA CUBA (RINSE HOLD) option has

been selected, the relevant light and the phase light

"FIN" (END) are on to indicate that the water must be

emptied out before opening the door.

To do this first turn the programme selector dial to "O"

and then to drain programme

. The spin programme is

performed at the maximum speed. In order to avoid

any creasing or damage in synthetic, delicate and

wool items, the spin speed must be reduced by

turning the speen selector dial.

At the end of the programme turn the programme

selector dial to "O" to switch the machine off.

Remove the laundry from the drum and carefully

check that the drum is empty.

If you do not intend to carry out another wash, close

the water tap. Leave the door open to prevent the

formation of mildew and unpleasant smells.

or spin programme