Zanussi ZWQ 5100 Manuel de l'utilisateur - Page 8
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Zanussi ZWQ 5100. Zanussi ZWQ 5100 13 pages. Top-loading washing machine
Également pour Zanussi ZWQ 5100 : Manuel de l'utilisateur (13 pages)
Imprimer la page
Problems
You have found water around
the washing machine:
Wash is unsatisfactory:
The appliance vibrates, is
noisy:
The wash cycle is much too
long:
The washing machine stops
during a wash cycle:
The lid doesn't open at the
end of the cycle:
Softener runs directly into
the drum when filling the
dispenser box:
The "Start/Pause" pushbut-
2)
3)
ton
flashes red
:
1) Depending on model.
2) On some models, the auditable signals can sound
8
• too much detergent has caused foam to overflow,
• the detergent is unsuitable for machine washing,
• the drainage U-piece isn't attached correctly,
• the drainage filter hasn't been put back in place,
• the water inlet hose is leaking.
• the detergent is unsuitable for machine washing,
• there is too much washing in the drum,
• the wash cycle is unsuitable,
• there isn't enough detergent.
• all packaging have not been removed from the appliance (see installation section),
• the appliance isn't level and is unbalanced,
• the appliance is too close to the wall or furniture,
• washing is unevenly distributed in the drum, the load is too small,
• the appliance is in running in period, noise will disappear with time.
• the water inlet filters are dirty,
• the power or water supply has been cut off,
• the motor overheating detector has been activated,
• the water inlet temperature is lower than usual,
• the foam detection security system has been activated (too much detergent) and the
washing machine has begun draining the foam,
• the out of balance detector has been activated: an extra phase has been added to
distribute washing more evenly in the drum.
• the water or electricity supply is defective,
• a Rinse hold has been selected,
• the drum shutters are open.
• the temperature inside the drum is too high,
• the lid unlocks 1 - 2 minutes after the end of the cycle.
• you have gone past the MAX indicator.
• the lid is not closed properly,
• the drainage filter is obstructed,
• the drain hose is blocked or bent,
• the drain hose is fixed to high (see "Installation" section),
• the drainage pump is blocked,
• the standpipes blocked,
• the water tap is closed, the water supply has been cut off.
Causes
www.zanussi.com