Zanussi DW 925 Livret d'instructions - Page 4
Parcourez en ligne ou téléchargez le pdf Livret d'instructions pour {nom_de_la_catégorie} Zanussi DW 925. Zanussi DW 925 18 pages. Dishwashers
Également pour Zanussi DW 925 : Livret d'instructions (20 pages)
Imprimer la page
INSTALLATION
Remove all packaging before positioning the ma-
chine.
Positioning
If possible, position the machine next to a water tap
and a drain.
The sides and the back of the dishwasher can rest
against the adjacent furniture or the wall.
The dishwasher features fill and drain hoses which
can be turned either to the left or the right to suit the
installation.
Levelling
Good levelling is essential for correct closure and
sealing of the door.
Loosen or tighten the adjustable support feet, until the
machine is perfectly level.
Adjusting the Worktop
You can move the work-
top forward or backward
by 25 mm in order to align
the machine with other
kitchen units.
Simply unscrew the two
front retaining screws,
(
move the top to the re-
son
:
quired position and then
retighten the screws.
By removing the machine's worktop, you can install it
under a close fitting sink unit or a pre-existing top, if
the dimensions of the recess correspond to those
shown in the picture.
Then proceed as follows:
Insert the machine after adjusting the height and level-
ling with the adjustable feet. When inserting the ma-
chine, ensure that the water inlet and drain hoses are
not kinked or squashed.
Caution
Once the machine has been installed, ensure that it
can be accessed easily for servicing.
Fitting a Decor Panel on the Door
The door of this machine has frames for fitting a plas-
tic laminate decor panel in the colour required to
match the dishwasher with the rest of the kitchen fur-
niture. If you wish to do this you must provide the
panel yourself.
Width:
588 mm
Height
586 mm
Max thickness:
4mm
To Fit the Panel
Take the door frame off after removing the retaining
screws around the edge.
Position the panel, refit the frame and tighten the re-
taining screws around the edge.
SS
Note
The panel should be fitted before positioning the ma-
chine.