Directed Directechs DB3 Manuel d'installation - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Directed Directechs DB3. Directed Directechs DB3 19 pages. Smart key for 2013 toyota highlander
Également pour Directed Directechs DB3 : Manuel d'installation (20 pages), Manuel (6 pages), Manuel d'installation (18 pages), Manuel d'installation (18 pages), Manuel d'installation (19 pages), Manuel d'installation (20 pages), Manuel d'installation (19 pages), Manuel d'installation (20 pages), Manuel d'installation (10 pages), Manuel d'installation (19 pages), Manuel d'installation (19 pages), Manuel d'installation (20 pages), Manuel d'installation (20 pages), Manuel d'installation (20 pages), Manuel d'installation (10 pages), Manuel d'installation (20 pages), Manuel d'installation (20 pages), Manuel d'installation (19 pages), Manuel d'installation (20 pages), Manuel d'installation (20 pages), Manuel d'installation (18 pages), Manuel d'installation (20 pages), Manuel d'installation (19 pages), Manuel d'installation (19 pages), Manuel d'installation (18 pages), Manuel d'installation (19 pages), Manuel d'installation (20 pages), Manuel d'installation (18 pages), Manuel d'installation (19 pages), Manuel d'installation (20 pages), Manuel d'installation (20 pages), Manuel d'installation (20 pages), Manuel d'installation (18 pages), Manuel d'installation (20 pages), Manuel d'installation (19 pages), Manuel d'installation (20 pages), Manuel d'installation (18 pages), Manuel d'installation (19 pages), Manuel d'installation (20 pages), Manuel d'installation (17 pages), Manuel d'installation (20 pages), Manuel d'installation (18 pages)

Imprimer la page
Directed Directechs DB3 Manuel d'installation

Pre-installation and application warnings

Firmware notes: This section highlights important information for this specific firmware and will assist in
pricing accordingly, as well as bringing awareness to any operational or vehicle limitations.
T-Harness
compatible
Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic
Š
connector.
No takeover feature is available.
Š
To remote start the engine, the hood, hatch, and all doors must be closed.
Š
By default, the tach is set to 1000 rpm on hybrid vehicles.
Š
Keyless and Smart Key will remain functional during remote start on hybrid vehicles.
Š
If the vehicle is already equipped with an OEM remote starter, the installer must disconnect it before installing the DB3
Š
module, otherwise it will not program.(For more information see "OEM remote starter detection")
Refer to "Vehicle connections" following the wiring diagram.
Š
General notes: This section highlights important information for this specific firmware.
Tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D.
[1]
Connection required ONLY if Pit-Stop/Idle mode is desired.
[2]
5
Keys required for
1
Keys required for
programming
operation
403.TL6 2.17 2014 Toyota Avalon (Smart Key)
© 2018-02-23 Directed. All rights reserved.
0