Zanussi ZDT26030FA Manuel de l'utilisateur - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Zanussi ZDT26030FA. Zanussi ZDT26030FA 21 pages.
Imprimer la page
CANCEL PROCEDURE
Use CANCEL to:
•
Cancel a currently running programme.
•
Stop the countdown of Delay option.
•
Bring the appliance back to the programme
selection mode.
To CANCEL:
Press and hold CANCEL until the control panel
indicates the appliance is in the programme
selection mode.
USER MODE
Settings available in the user mode:
•
The level of the water softener according to the
water hardness.
•
Activation or deactivation of the rinse aid empty
notification.
•
Activation or deactivation of the acoustic signal
indicating the end of a programme.
•
Activation or deactivation of AirDry.
Before entering the user mode, make sure the
appliance is in the programme selection mode.
To enter the user mode:
Press and hold simultaneously
least 3 seconds.
The indicators:
,
THE WATER HARDNESS TABLE
German degrees
(°dH)
47 - 50
43 - 46
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
<4
1) Factory setting
2) Do not use salt at this level.
and
,
, and
start flashing.
French degrees
(°fH)
84 - 90
76 - 83
65 - 75
51 - 64
40 - 50
33 - 39
26 - 32
19 - 25
7 - 18
<7
As the appliance stores the saved settings, there is
no need to configure it before every cycle.
ADJUSTING THE WATER SOFTENER
Make sure the appliance is in user mode.
1. Press
•
The indicators
•
The indicator
•
The display shows the current setting: e.g.
2. Press
of the button
one. After reaching level 10, the count starts
from level 1
3. Press the on/off button to confirm the setting.
If you use multi-tablets containing salt
and the hardness of your water is
lower than 21°dH, you can set the
lowest water softener level. It
deactivates the salt refill indicator.
If you use standard detergent or
for at
multitablets without salt, set the proper
water hardness level to keep the salt
refill indicator active.
mmol/l
8.4 - 9.0
7.6 - 8.3
6.5 - 7.5
5.1 - 6.4
4.0 - 5.0
3.3 - 3.9
2.6 - 3.2
1.9 - 2.5
0.7 - 1.8
<0.7
.
,
and
still flashes.
= level 5.
to change the setting. Each pressing
increases the level number by
Clarke degrees
58 - 63
53 - 57
46 - 52
36 - 45
28 - 35
23 - 27
18 - 22
13 - 17
5 - 12
< 5
are off.
Water softener
level
10
9
8
7
6
1)
5
4
3
2
2)
1
7