Zanussi ZT 605 Livret d'instructions - Page 14
Parcourez en ligne ou téléchargez le pdf Livret d'instructions pour {nom_de_la_catégorie} Zanussi ZT 605. Zanussi ZT 605 15 pages. Dishwashers
Également pour Zanussi ZT 605 : Livret d'instructions (16 pages), Livret d'instructions (20 pages)
Imprimer la page
BUILDING-IN
Building-in features
This dishwasher is designed to be fitted under a kitch¬
en counter or sink.
In either case, it is essential that the recess dimensions
indicated in the picture are followed.
No further openings for venting of the dishwasher are
required, but only to let the water fill and drain hoses
and power supply cable pass through.
The recess height may be anywhere between 820 and
880 mm from the floor since the dishwasher incorpo¬
rates levelling feet adjustable over a wide range (max
60 mm).
Adjust the height of the appliance by turning these
feet.
A distance of 2 mm should be allowed between the top
of the dishwasher and the counter top.
To make it easier sliding
in and sliding out of the
appliance, fit the pads
supplied by pressing
them on the feet as
shown in the figure.
Fitting the vapour protection
Fit the adhesive alumini¬
um protection at the front
recess, under the work¬
top, along the entire
width.
Fitting under a counter {kitchen worktop
or sink)
It is absolutely essential that the dishwasher is discon¬
nected from the electricity supply before gaining ac¬
cess to any internal component.
Fit the dishwasher into the appropriate housing space
and connect it. Make sure that the water fill and drain
hoses and the power supply cable are not bent or
kinked.
Fitting the panel onto the door
The door on this model is designed for the overlay of a
panel having the following dimensions:
Width:
596 mm
Height:
644 to 714 mm max
Thickness:
20 mm max
Weight:
2 to 7.5 kg max
Note:
The panel height should not be more than what indi¬
cated, otherwise complete opening of the door will no
longer be possible as the panel hits against the dish¬
washer plinth.
Mounting of decor panel onto the door
The height of the panel depends on the height of the
plinth of adjacent kitchen units (see kitchen plinth ad¬
justment).
The panel must be fitted
with a handle, as the
dishwasher handle will be
hidden by the panel.
Drill the panel with a 0
2x12 bit according to the
dimensions indicated in
the figure.
Fix the cross bar onto the panel using four 3.5x16
screws provided. Reduce the lenght of fixing screws
according to thickness of panel.
If for aesthetic matching
the panel is provided with
a false drawer (fitted or
carved on the panel it¬
self), the two brackets
provided should also be
used. Fix the brackets
according to the meas¬
urements shown in the
figure, by using four
3.5x16 screws.
Reduce the lenght of fixing screws according to thick¬
ness of panel.
596 max
=
546
_=
O'
o
Tf ,
0
0
.
O'
o
CO
5
:
CO
I.S374